Electronics Forum | Fri Dec 27 07:20:38 EST 2019 | dipak123
We have Mirtec MV-6 OMNI machine. If programer changes in part number ,then that part x-out from it's place.Value of X & Y incresed 10X compare to other parts in ATT.
Electronics Forum | Wed Jul 22 13:57:03 EDT 1998 | bill
| | We need BGA rework station and x-ray inspector recently in urget case, Do you have any information to rework FPGA package and inspect them during processing. | Thx for any information | Best Regards, | Stoney Tsai If you are doing any reballing
Electronics Forum | Tue Sep 12 11:55:30 EDT 2000 | Mike F
In general I agree with Dave and Chris, but some parts have leads that can't be clinched (connectors, some header sticks, etc.). If the problem part has not been a floater in the past, then check the lead finish and your flux application. A bad finis
Electronics Forum | Thu Apr 19 20:01:30 EDT 2012 | eadthem
some things to consider, Is there flux on the board. are there finger prints on the tops of parts. Is the board warped at the V score from reflow Is the board shifting in the machine during inspection. These are the issues we have had with our mir
Electronics Forum | Thu Aug 18 09:41:05 EDT 2016 | jbuckley
Typically on my company's Mirtec systems, any anomalies, such as cracks, chips, etc. on chip capacitors and chip resistors are going to be detected with just a basic mounting inspector. We have a full image of the part (solder joint not included) as
Electronics Forum | Mon Feb 07 18:12:56 EST 2011 | eadthem
I do not know what software version you have, but on older versions it is best to have a mounting inspector set to be the primary and then mask out all labels and solder so it just locates the part. Then add another mounting inspector for looking at
Electronics Forum | Mon Jan 10 18:35:05 EST 2011 | eadthem
Ive used a Mirtec machine for 3 years MV3L with side angle inspection. Mirtec has some issues documentation, and repair plus. But there machine is impressive and the AOI software is good. We can find about 90-99.99% of all errors using just the 5
Electronics Forum | Tue Jan 25 14:12:55 EST 2011 | rodrigo
Hi All, I've been working with this machine for several weeks. I read the manual and I'm using the autoprogramming (ATT) with centroid data. I have a question regarding the teaching of the parts. Let's say I have 10 capacitors on the PCB that are th
Electronics Forum | Fri Nov 05 18:47:31 EDT 2010 | eadthem
I'm guessing when you say bare board you mean wet paste only? When you say the pads move slightly are your boards warped at all at the Vscore? What we do is use per modual fids. first you delete or don't make panel fids and then theres a option wh
Electronics Forum | Thu Jan 13 20:40:47 EST 2011 | eadthem
properties > settings > troubleshooting > Set hardware acceleration to NONE > apply OK apply OK reboot. without this any attempt to take a screen shot of the program will not save the image (because in a fruitless attempt to speed it up they have pr
.gif)
