Electronics Forum | Fri Jan 11 08:12:44 EST 2008 | gcamac
Mirtec can set you up to download the latest software. Go to their web site for information.
Electronics Forum | Mon Jul 23 20:03:19 EDT 2012 | hegemon
You'll need to login with Admin rights to apply those settings. Mirtec used to use pretty simple default passwords for admin as I recall. Check the manual, the default logins should be there. 'hege
Electronics Forum | Fri Jun 17 17:11:59 EDT 2005 | stansmt
I have been working with the Yestech system in my facility after evaluating the Mirtec. The yestech system has far less false calls and better defect coverage based on the test vehicles I ran. The YTV-1000 out performed the Mirtec in defect detection
Electronics Forum | Fri Feb 01 18:07:10 EST 2013 | hegemon
Phase 1 Seems expensive, but I assure you, the $ outlay will be well worth it in the long run. If you are new to AOI, or new to Mirtec AOI, my suggestion would be to register your machine with Mirtec, and then take advantage of the support they offer
Electronics Forum | Mon Nov 20 14:48:35 EST 2023 | proceng1
Have you reached out to MIRTEC? They can easily connect through Teamviewer and check your settings and see what you see live. It would be way more effective than someone trying to troubleshoot by email. The support tech that we usually get really
Electronics Forum | Fri Jan 14 15:36:15 EST 2011 | bdamico
Hello eadthem, MIRTEC sells a center board support for our desktop series. Please contact our office directly for more information regarding this option. I beleive that we might be able to offer you additional assistance with your side angle progr
Electronics Forum | Tue Oct 03 18:13:46 EDT 2023 | glasscake
Its ether going to be in the settings before launching the software at the login screen or the settings after launching the softer on the top right. You should see some tab relating to defects. There should be a setting that says something along the
Electronics Forum | Tue Dec 13 07:01:56 EST 2005 | clampron
Good Morning, We are currently using 4 Mirtec machines. We decided on the Mirtec after a side by side evaluation of several tabletop machines. I have to admit that Yestech was not one of them. However, after the evaluation, the Mirtec outperformed t
Electronics Forum | Fri Mar 04 18:08:26 EST 2011 | eadthem
There is a option to enable no good marking that must be enabled on the board options where you reset your board count and images. dose the marker zero on startup?. If not then it may also need enabled in the inspector settings. ead
Electronics Forum | Thu Aug 18 09:41:05 EDT 2016 | jbuckley
Typically on my company's Mirtec systems, any anomalies, such as cracks, chips, etc. on chip capacitors and chip resistors are going to be detected with just a basic mounting inspector. We have a full image of the part (solder joint not included) as