Electronics Forum | Mon Nov 20 16:10:58 EST 2023 | kghadiya
I tried to reach them out but our machine is not registered on their site so they asking big amount to register and then support. That's the only reason I am asking for help in this forum.
Electronics Forum | Mon Nov 20 14:48:35 EST 2023 | proceng1
Have you reached out to MIRTEC? They can easily connect through Teamviewer and check your settings and see what you see live. It would be way more effective than someone trying to troubleshoot by email. The support tech that we usually get really
Electronics Forum | Thu Nov 16 11:11:56 EST 2006 | jhaviland
I have worked with both Mirtec and Yestech and you really can't go wrong with either, they both have a good support group if you need it. by my take on the 2 is that yestech is a little less comprehensive inspection wise and a little slower than Mi
Electronics Forum | Tue Nov 07 14:23:13 EST 2006 | CL
Hello bpeach, We purchased a Mirtec for our first AOI machine after a side by side comparison of three different manufacturers. The Mirtec proved to be far superior to the others that we had looked at. Initially, the intention of the AOI was to prov
Electronics Forum | Thu Feb 11 15:11:57 EST 2010 | hegemon
Speaking from experience, my vote goes to Mirtec MV-3 or MV-7 with the 4 Megapixel camera setup. 2 Megapixel cams won't inspect that small, other than for presence Yestech also has machines that are suitable for this work. No company affiliations,
Electronics Forum | Wed May 09 05:54:51 EDT 2012 | pvasquez
Hello thomas31, When we did our equipment evaluation, we looked at all of these systems with the exception of Goepel. My team and I thought that the image quality of the Mirtec machine was by far the best of any of the other vendors. We also found t
Electronics Forum | Fri Sep 05 19:56:56 EDT 2008 | hegemon
We did extensive side by side (by side) testing of three AOI machines Omron, YesTech and Mirtec. In the end, even with weighted scores, the difference in the top two machine was still only four/tenths of a point. Third place was a distant 14 points
Electronics Forum | Fri Aug 07 14:52:43 EDT 2020 | glasscake
Does anyone have a comprehensive manual or some pages on how to setup/how the laser height functions work on a Mirtec MV-7U? (Mirtec Inspector 4.5.6) Even a sentence describing what each input for these tools do would be amazing. I FINALLY was able
Electronics Forum | Thu Feb 11 06:50:17 EST 2010 | CL
Good Morning Bryan, We are using Mirtec MV-3 AOI's with 4 megapixle cameras. We use them for 100% post reflow. We are checking, presence, polarity, value, solder, bridging,component height for BGA, QFN etc... and 1st piece validation for machine set
Electronics Forum | Fri Nov 05 18:47:31 EDT 2010 | eadthem
I'm guessing when you say bare board you mean wet paste only? When you say the pads move slightly are your boards warped at all at the Vscore? What we do is use per modual fids. first you delete or don't make panel fids and then theres a option wh
