Electronics Forum | Mon May 06 11:50:15 EDT 2019 | sankarseptember
I am using siplace XS Series mounter..I am getting component missing.. atleast one or two per shift production..I wonder this machine don't have option to check at last if any miss or thrown up component.what I need to check? I need any expert in sip
Electronics Forum | Wed Jun 05 10:16:29 EDT 2019 | emeto
Sankar, it looks like you need an expert to help you. Missing component might be related to hardware, machine setup or software issues on you equipment which will require a tech or engineer to investigate.
Electronics Forum | Mon May 06 16:34:20 EDT 2019 | tey422
First of all, I am not familiar with the machine you stated. But there is something you should check out. That is if the nozzle tips having solder paste stick to it or not. If nozzle tips having a fresh paste stick to it, the component might not a
Electronics Forum | Tue May 07 12:50:17 EDT 2019 | sankarseptember
Thanks for the response Thomas..You are correct I got solder paste on both edge on the nozzle type 4007. But it uses for nearly 30 types of part number ..and also I will get missing without any issues in nozzle..I am unable to find the trace in that.
Electronics Forum | Tue May 07 13:49:05 EDT 2019 | tey422
Like I stated before, I am not familiar with the machine. I can only make suggestions. If you found solder paste on the nozzle, clean it off to prevent part stuck to the nozzle tip. I would also check if the nozzle tips are being worn off; uneven we
Electronics Forum | Wed May 08 07:19:03 EDT 2019 | youngbuck
Hi Sankar, I have had experience with the SX and X2 so I'm not sure how similar ours is to yours but i can give you some suggestions. 1. As Thomas said you could do a vaccum check and make sure the 4007 nozzle has around the same settings as the ot
Electronics Forum | Fri Mar 11 10:47:24 EST 2005 | thaqalain
(1)While fixing feeders to reels ,some small componets are displaced or fell down out of reel and there will be discontinuty.In-fact there will be probability of this till we load magazines to machine. Is there any effect, I mean ultimately,will we g
Electronics Forum | Fri Mar 11 12:04:15 EST 2005 | thaqalain
Thanx JB, we have MY DATA MACHINE AND CONCEPTRONICS OVEN
Electronics Forum | Fri Mar 11 11:40:23 EST 2005 | JB
If there is an empty pocket at the pick up position, because a component "fell off" then the pick and place machine will attempt to pick up more components from the same feeder an "x" amount of times, depending on your component parameters, then it w
Electronics Forum | Fri Mar 18 14:27:29 EST 2005 | pmd
Hold on, MyData can place no component and not detect error if the minimum and maximinum settings in the centering phase are within the mesurement of the tool it'self. Especially if the levels are down between the jaws. For insurance make sure the to
