Electronics Forum | Fri Jul 27 12:21:18 EDT 2012 | tpatrickwalsh
I am posting this here because I think it may have something to do with PCBA: I have a simple battery-powered consumer product (LED light) that we have been manufacturing for some time. All of a sudden in one batch, we have about a 4% rate of a sing
Electronics Forum | Wed Aug 22 12:44:26 EDT 2012 | rway
I would look at your de-paneling process. How are you cutting the boards? This could be inducing mechanical stress on the component; especially if the part is close to the edge of the pcb and perpendicular to it.
Electronics Forum | Fri Jul 06 03:23:01 EDT 2001 | kennyhktan
Hi there Steven ! Please allow me to share some of my problem we're facing here with you. Here are a few points that I suggest you should check on your current process:- (1)PCB - Component land partern design ? It is per IPC spec ? - Mask
Electronics Forum | Wed Jan 26 21:23:51 EST 2000 | Dennis
Hello! all Will anybody give me advice for missing componets for 0402, 0603 R or C chips? I am not gonna tell you which machine I use, but from my experience, every p&p machine has possibility for missing component after placing 400 or more componen
Electronics Forum | Sat Dec 13 08:03:46 EST 2003 | Stefan Witte
The only part, which could cause component misplacement on the rotary heads of the Siplace machine is the vacuum valve. I don�t know the official name in the part catalog, but I use to name it plunger. The plunger is moved in and out by a miniature s
Electronics Forum | Tue Aug 25 20:33:31 EDT 1998 | Karlin
| | | | Hi, | | | | Does anyone has experiences in reflowing Ceramic BGA and found solder wicking ? Solder wicking has the syndrome that solder being wick from the pad and ended up in the leads. | | | | We have rule out the possibility of not printin
Electronics Forum | Tue May 07 13:49:05 EDT 2019 | tey422
Like I stated before, I am not familiar with the machine. I can only make suggestions. If you found solder paste on the nozzle, clean it off to prevent part stuck to the nozzle tip. I would also check if the nozzle tips are being worn off; uneven we
Electronics Forum | Wed May 08 07:19:03 EDT 2019 | youngbuck
Hi Sankar, I have had experience with the SX and X2 so I'm not sure how similar ours is to yours but i can give you some suggestions. 1. As Thomas said you could do a vaccum check and make sure the 4007 nozzle has around the same settings as the ot
Electronics Forum | Thu Aug 27 15:40:50 EDT 1998 | Justin Medernach
| | | | | Hi, | | | | | Does anyone has experiences in reflowing Ceramic BGA and found solder wicking ? Solder wicking has the syndrome that solder being wick from the pad and ended up in the leads. | | | | | We have rule out the possibility of not p
Electronics Forum | Thu Jul 21 02:45:51 EDT 2005 | Base
Probably very far-fetched, but I can think of a scenario like this: - machine picks up a component - between vision and placement the part is lost, but the loss is not detected due to oversize tool, which causes the amount of vacuum drop to go unnot
winsouce.jpg)