Electronics Forum | Wed Mar 18 09:52:40 EDT 2015 | rgduval
You'll want to double check the electronics in the magazines, as well as the mechanicals. Over time, the connectors can come loose, and could affect performance. I'm thinking of the "dead" feeder that you mentioned, while the rest of the feeders wo
Electronics Forum | Wed Sep 05 16:49:04 EDT 2007 | dilogic
We have a bad EXP_VIDEO card that needs repair. I've asked UIC, but they ignored several e-mails (although machine's software is properly registered). Does anybody know a company that does such things? - Dejan
Electronics Forum | Thu Dec 13 05:58:05 EST 2018 | ccarterr
Hello, I have re4ecently been tasked with maintaining/repairing several Juki 750-760 SMT machines. Are there any online resources or training available that would help me in my endeavors?
Electronics Forum | Wed Jun 29 03:23:10 EDT 2005 | dougs
We used to use a company in the uk that did this, we stopped as the results were never that good, i think the company stopped offering the service as well as no-one else wanted to have their nozzles repaired, it's best to get new nozzles in and make
Electronics Forum | Thu Jun 02 11:16:23 EDT 2005 | JH
I concern about the Through Hole soldering as well. Currently, we have encountered some problems of Multilayer from Through Hole soldering. The root-cause is probably related to PCB Finish, machine setting, Thermal relief Pad or hole and something e
Electronics Forum | Wed Jun 24 14:31:36 EDT 2020 | kumarb
Thank you so much for your comments. It sounds very logical as the probes are indeed the original along with the rest of the insides of this machine (270 hours of on time). The entire module is offset by 50-75 degrees cooler so suspecting that the pe
Electronics Forum | Wed Jun 24 21:33:39 EDT 2020 | rgduval
Heller is great about their support (at least, they always have been in my past lives). Especially if you bought the machine new. I would suggest giving them a call, and seeing what they can do to help you. They have also turned up in these forums
Electronics Forum | Tue Jun 23 22:19:33 EDT 2020 | kumarb
Hi. Have an older 1809EXL that was purchased new and has sat idle for years with 270 on hours as of today. After days of testing, unable to melt fresh paste from Loctite (SAC305). The root cause after the investigation is due to one of the 2 TDM modu
Electronics Forum | Wed Aug 10 14:11:38 EDT 2005 | rrylande
Does anyone have suggestions or observations on what my maximum board temperature should be when doing BGA repairs on an SRT? In other words, How hot is too hot? Somebody set the bottom heater on our new BGA repair machine to blow at 275 C, and our
Electronics Forum | Wed Aug 10 14:56:03 EDT 2005 | pjc
"Too Hot" is any more heat than what is needed to reflow the solder. You should have the Auto-Profile software for the machine, this will accurately monitor and record temps. There is also port for the component itself to monitor package temp. There
