Electronics Forum | Fri Dec 19 11:32:46 EST 1997 | Kris Ganev
Can anybody give me feed back on the pro and cons of using Pace, OK, Hakko, Metcal, etc... equipment in their rework processes? I need to set up a low volume rework station for mixed technology boards. Would appreciate any suggestions.
Electronics Forum | Thu Jul 12 20:58:30 EDT 2001 | davef
ERSA and PDR Xytronic both make very respectable lower priced rework equipment.
Electronics Forum | Tue Jun 15 15:10:44 EDT 2004 | mrmaint
Looking for feedback on an Airvac DRS24C Bga rework station. Looking for both good and bad feedback. Users only please, no sales folks. Thanks MRMAINT
Electronics Forum | Thu Jun 08 06:08:06 EDT 2000 | jacqueline coia
Hi There, I know this is a long shot but does anyone in Scotland have a 31mil nozzle for an Airvac rework station that they are willing to hire out for a short period of time? Also is there any papers or sites that can give good technical advice on B
Electronics Forum | Thu Aug 16 15:29:30 EDT 2001 | steven
When Air-Vac introduced an IR system at a show in San Jose, people though it was the greatest thing since sliced bread. For obvious reasons they discontinued the short life of the IR systems and implemented hot air into their rework stations. Sales
Electronics Forum | Tue Feb 05 16:06:48 EST 2013 | mlevesque
We are looking for a new BGA rework station. We got an ERSA IR550A and we are not very satisfied. I'm not sure that IR reflow is the better solution because the top-side heating is too large. I think is better with a convection "forced-air" heat.
Electronics Forum | Thu Jul 12 15:09:59 EDT 2001 | larryk
I am currently looking into purchasing a BGA rework station. Most of the various manufactures use convection heat, but Ersa was different in that they use IR. I know and understand the difference between the two types, but I was wondering if any body
Electronics Forum | Tue Feb 05 20:31:39 EST 2013 | hegemon
Air Vac DRS25. Hands down the best rework EQ. (my humble opinion, based on my own experience with rework EQ going back 15 years +) Right in your budget. Complete capability for rework. SMD, BGA, POP. Full profiling capability. Massive bottom heati
Electronics Forum | Wed Dec 24 22:46:58 EST 1997 | Scott McKee
| Can anybody give me feed back on the pro and cons of | using Pace, OK, Hakko, Metcal, etc... equipment in | their rework processes? I need to set up a low volume | rework station for mixed technology boards. | Would appreciate any suggestions. I
Electronics Forum | Thu Aug 16 04:54:44 EDT 2001 | mugen
METCAL has a good unit, for BGA rework, and it uses Hot Air Reflow (convection). The pros and cons of Hot Air Vs IR, you can find easily ard u... em are ageless topics, happy debating. hint : good reasons why SMT Reflow Ovens, were IR switched to
winsouce.jpg)
