Electronics Forum | Mon Jan 28 12:09:27 EST 2002 | billschreiber
Hello Carl, Smart Sonic has introduced the Assembly Module for off line programming of assembly equipment such as GPD. You can see it on the Smart Sonic website: http://www.smartsonic.com Click on the AOI/StencilScan and GlueScan link. If you hav
Electronics Forum | Fri Mar 03 13:41:43 EST 2000 | pr
Is it o.k. to clean my glue stencils in the same IPA stencil cleaner I use for solder paste? Also if anyone with experience in stenciling glue can lead me away from first time pitfalls I would appreciate that as well. thanks in advance
Electronics Forum | Fri Mar 03 13:41:43 EST 2000 | pr
Is it o.k. to clean my glue stencils in the same IPA stencil cleaner I use for solder paste? Also if anyone with experience in stenciling glue can lead me away from first time pitfalls I would appreciate that as well. thanks in advance
Electronics Forum | Thu Jan 03 11:28:11 EST 2013 | beej
I have had a couple like this. It almost seems like they are not threaded correctly. I had to mangle the last one just to get it off.
Electronics Forum | Thu Jan 03 11:25:07 EST 2013 | dontfeedphils
That's weird, I've never had any problems using the tool while the pot is up to temp. Over-tightened? They don't need to be tightened too much when putting them in.
Electronics Forum | Tue Jan 03 08:17:53 EST 2006 | chunks
We have a conveyor then a FIFO in the middle and a conveyor and a Mag loader at the end. If your oven doesn't have SMEMA (like ours) then you need to the conveyor before each. We trick these conveyors by shorting out the in coming SMEMA so they con
Electronics Forum | Thu Jan 03 10:32:38 EST 2013 | beej
I was wondering if any of you fine folks had a trick to changing out nozzles for a Pillerhouse Jade Handex. The tool they gave us when we purchased the machine is inadequate at best. I have tried heating the nozzle up, to no avail. Just wondering if
Electronics Forum | Thu Jan 03 14:19:33 EST 2013 | uksolder
Beej, The tool supplied works well as long as the bath is up to temp and the nozzle tip was not cross threaded when fitted. Did you apply a small amount of the anti seize paste before the nozzle tip was fitted? I have seen dry tight threads if not ap
Electronics Forum | Fri Mar 03 14:08:55 EST 2000 | Michael Parker
Your best answer for determining cleaning method is to contact your stencil supplier and follow their recommendation. Periodic inspection of your apertures (using microscope, or minimum 10x magnification) would also be a good idea to make sure that g
Electronics Forum | Fri Mar 03 14:08:55 EST 2000 | Michael Parker
Your best answer for determining cleaning method is to contact your stencil supplier and follow their recommendation. Periodic inspection of your apertures (using microscope, or minimum 10x magnification) would also be a good idea to make sure that g