Electronics Forum | Thu Mar 01 09:14:06 EST 2001 | Dale Dolan
Dek 265 Get yourself Formflex tooling for quick changeover time. The principle being tooling pins are raised by a combination of pneumatic's and hydraulics to meet the underside of the pcb which rises to print height. No longer will u have to judge
Electronics Forum | Thu Oct 23 15:23:28 EDT 2025 | sarason
~100 mV on logic rails can break comms. • Inspect and reseat edge and ribbon connectors; clean oxidised contacts; verify chassis ground and shield continuity. 3. Comms layer sanity check • Trace the cable from the CPU/HMI to the module: many o
Electronics Forum | Fri Apr 20 10:17:47 EDT 2018 | sarcher
We purchased a ERSA Wave Solder 330-F machine recently "As Is", with NO warranty. Trying to get the machine started, we've ran into trouble with the Spray Fluxer ESF. During the initial verification run, the spray fluxer would move 4 times to the ce
Electronics Forum | Mon Sep 03 21:33:41 EDT 2018 | aemery
Jeff R, The "24VS" stands for 24VDC Voltage Switched; meaning that it is supplied under machine control and other things have to happen in the machine before 24VS is applied, in this case to KP1 coil. KP1 coil/contact is in place as part of the pow
Electronics Forum | Wed Feb 20 15:21:56 EST 2013 | rmitchell
Hi, hopefully I am too late, it is fixed and you are up and running. Have you tried MPM support on the phone? We have 2 older MPM's and the blow the driver modules in the bottom drawer on the back of the machine. There are different drivers for dif
Electronics Forum | Thu Jul 13 22:20:38 EDT 2000 | Dave F
=10 mils larger than lead 3 silk screen legend text weight >=10 mils 4 pads >=15 mils larger than finished hole sizes 5 place through hole components on 50 mil grid 6 no silk screen legend text over vias (if vias not solder masked) or holes 7 so
| 1 |
