Electronics Forum | Fri May 21 11:59:24 EDT 1999 | John Eramo
Has anyone had any experience or data using vibration during the reflow process. We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process worked very
Electronics Forum | Sun May 23 07:13:56 EDT 1999 | Scott Cook
| Has anyone had any experience or data using vibration during the reflow process. | We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process worked v
Electronics Forum | Sun May 23 10:14:14 EDT 1999 | M Cox
| Has anyone had any experience or data using vibration during the reflow process. | We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process worked v
Electronics Forum | Fri May 21 12:25:14 EDT 1999 | Dave F
| Has anyone had any experience or data using vibration during the reflow process. | We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process worked v
Electronics Forum | Tue May 25 09:19:00 EDT 1999 | Ricardo Lopes
| | Has anyone had any experience or data using vibration during the reflow process. | | We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process work
Electronics Forum | Fri May 21 15:23:24 EDT 1999 | JohnW
| | Has anyone had any experience or data using vibration during the reflow process. | | We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process work
Electronics Forum | Mon May 24 09:52:06 EDT 1999 | john thorup
| | | Has anyone had any experience or data using vibration during the reflow process. | | | We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process
Electronics Forum | Mon Sep 10 12:27:32 EDT 2007 | hakerem
Hi Dave - You are correct that I was not clear in my comments. I assumed Joris had seen the usual solder balls accompanying his blowholes. Nevertheless, Joris, my first two recommendations still stand. Increasing the dwell time of your leads in t
Electronics Forum | Mon Aug 12 12:58:16 EDT 2002 | pjc
What I've done w/ eutectic ball BGA devices is after removing the BGA from the PCB, solder-suck the lands- get em nice a flat, apply a thin coat of gel flux to the solder lands and then a thin coat to only the bottom of the solder balls on the new BG
Electronics Forum | Fri Sep 28 09:30:07 EDT 2001 | kmorris
Just had a similar phenomenon 2 days ago. May relate to your issue --- or not. Like you, I did a once over looking for mechanical obstruction & couldn't find any. Ran a thermal profile on the offending PCB & all checked out. Looked in end of oven
.gif)
