Electronics Forum | Mon Mar 10 14:13:36 EST 2003 | msivigny
Hello Bill, As I mentioned in an earlier thread, I was not familiar with the PAM system but have since been given a quick run down on how it performs its measurement routine. It is an acceptable way to measure and optimze Fuji chip shooter performanc
Electronics Forum | Tue Jan 13 19:16:42 EST 2004 | gregp
Ron, No one asked you about future of Contact Systems. It sounds like you are feeding on the B.S. magellan has been telling everyone. Why don't you get your information from reliable sources (such as Contact Sytems) rather than those with obvious a
Electronics Forum | Sat Jul 25 11:11:09 EDT 1998 | Mike Moninger
| Be consistant on: | 1 Keeping the coating material thinned. | 2 Using the same dipping motion on each board. Amen on thinning the coating, and you might also be concerned about the curing mechanism for the coating. Moisture-cured and 2 component
Electronics Forum | Fri Sep 04 02:09:03 EDT 2009 | sachu_70
Hi Walter, Do you refer to a sprayfluxer operation? The problem seems to be a parameter setting issue. 1. Ensure the wide angle spray reaches PCB with optimum jet pressure. You could pass a glass plate to understand flux coverage and view Jet pressur
Electronics Forum | Fri May 24 09:19:02 EDT 2019 | davef
http://www.nordsonselect.com. Accel: Cookson created Speedline after purchasing: MPM®, Electrovert®, Accel®, and Camalot®. In 2003, KPS Special Situations Fund II purchased Speedline from Cookson. In, 2007, Illinois Tool Works ITW acquired Speedlin
Electronics Forum | Wed Jan 26 10:15:04 EST 2000 | Christopher Lampron
Maurice, I have worked with several different platforms of P&P machines and have a couple of thoughts regarding features and ease of use. The Contact Systems 3 series machines are versitile and very user friendly. I contribute this to the touch scree
Electronics Forum | Sat Jan 10 15:19:28 EST 1998 | Jon
Check out the web site www.conceptronic.com I think you will see that the Conceptronic ovens are the best and most reliable over the long haul. Micron CMS has over thirty five of them and has stated that they were the most reliable and best vendo
Electronics Forum | Fri Apr 27 12:08:43 EDT 2007 | Machine Designer
In the infamous words of one of my good customers. "Vision systems suck, it's just that some suck less than others" and he would know having hand built AOI systems internally for over 10 years. Do you have any idea how many people think one-off mac
Electronics Forum | Thu Jul 23 13:23:45 EDT 2020 | bmalhi
Small components blown issue could be due to one of the below. - Process issue; Make sure solder paste is fresh, if flux is drying out it will not hold parts properly. Check downward pressure of Pick Place. SOT may have to be pushed a little harder i
Electronics Forum | Wed Apr 03 07:07:44 EDT 2013 | leemeyer
The manuals will not teach you how to use Autoprogram but they will be a reference once you learn it. First you must configure your system. Try this and let me know how it goes. To Configure a machine: -Under Machine Configuration Select Assembler/S
