Electronics Forum | Thu Jul 09 15:17:48 EDT 2015 | goodting
Thanks for the inquiry. We used MCD (Motion Control Dia) tool to verify if that is caused by VRM board. No respond(I means the related axis was off) was detected. we swapped that board to other machine, the VRM card was good.... X axis was stopped, t
Electronics Forum | Tue Jan 23 17:22:45 EST 2024 | tomdegas
For some reason I cannot load any tools on my MY12 machine. The machine goes through the motions like its loading the tool (grabbing it and putting it back) but at the very end it moves the carriage all the way to the right and wants me to put the t
Electronics Forum | Mon Jun 28 17:17:23 EDT 2021 | SMTA-64387687
The 2 big ribbon cables, on top of the X wagon. They run from the booster board, in the back, to the board on top of the X-wagon. They wear out and need to be replaced, periodically. Since, the tool cycle works, the Z-motion is probably working ok. I
Electronics Forum | Mon Oct 25 19:29:12 EDT 1999 | g cronin
hi mario there is a company called motion automated that makes a nifty press, i have one in my shop that i have used for a while. well built and they have been able to make me custom tooling as well at reasonable prices. i'm going to try to dig u
Electronics Forum | Tue Aug 06 16:48:19 EDT 2002 | Ozzy
Siemens has a software tool called SMMT that prompts when PM is needed based on actual machines usage, not the calander. All machine motions are tracked the PM prompt is given when the counter reaches the threshold. All PM steps are described in det
Electronics Forum | Wed Mar 07 12:57:55 EST 2018 | aemery
Gerber EZ is not available on the Accuflex platform. Speedline (now ITW EAE), like most manufactures, do not want to offer new tools on old platforms. There is one feature in the AccuPro software that I don't believe was added in any version of the
Electronics Forum | Thu Jul 04 17:48:28 EDT 2024 | assuredtech
I don't know who manufactures the SMT 460 machine or what it's capabilities and configuration or machine settings are applicable to this topic but some common process of eliminations are: Component packages (doesn't seem to be an issue here), Board s
Electronics Forum | Mon Apr 08 15:39:10 EDT 2024 | mistrthou
The error is: MOT-Command/205: Motor speed out of control Motor speed deviates from expected speed. – Problem with power supply, motor current too low. – Mechanical problem, friction too high or tool stuck in Z. I'd be looking at excessive friction
Electronics Forum | Fri May 24 09:19:02 EDT 2019 | davef
http://www.nordsonselect.com. Accel: Cookson created Speedline after purchasing: MPM®, Electrovert®, Accel®, and Camalot®. In 2003, KPS Special Situations Fund II purchased Speedline from Cookson. In, 2007, Illinois Tool Works ITW acquired Speedlin
Electronics Forum | Mon Jun 14 15:50:07 EDT 1999 | JohnW
| I am looking for more information about: | | 1) What kind of evaluation can I do to measure the resistance to fall off of a bottom side glueded SMT component?; | | 2) There is some influence of doble wave solder machine (temperature, flux, etc) i
