Electronics Forum | Fri Jan 06 09:39:35 EST 2023 | micropak
In newer machines, after changing a motor you have to do an "Axis Home Calibration". Once I changed Z-Axis belt on an SM-482 and it refused to successfully do "Axis Home Calibration. Then the solution was to remove the belt, rotate the motor pulley a
Electronics Forum | Wed Mar 26 19:00:48 EDT 2008 | darby
Also check your belts/tensions/pulleys and motors on the camera axis. If you are getting any slippage then the camera will not be in the position the encoder says it is. It may still read the fids but will produce an offset.
Electronics Forum | Thu Apr 13 16:21:29 EDT 2006 | jdengler
Make sure the pulleys on the motor and lead screw have not come loose. Look for damaged encoder wires in the cable way. If all of this mechanical stuff checks out then you probably have a bad encoder. Jerry
Electronics Forum | Tue Jan 11 09:58:18 EST 2005 | jdumont
Well we actually bought a used 3AV system. Been running with no problems at all for a while now. We also already had a 3Z system that has not fared so well. We have replaced both the Y motors, 3 of the 4 Z motors, belts, pulleys, PCB's, spindles...et
Electronics Forum | Tue Jul 15 16:26:14 EDT 2008 | lharris
Our company has a Novastar benchtop wave solder machine, WSL-P series, model 7PD. We need to replace the pulley drive motor/pump, as some of the teeth on one of the gears are worn down/gone. Any idea where I can procure a replacement? Please provide
Electronics Forum | Thu Jun 08 16:33:47 EDT 2017 | sumote
This may not be a solution to your problem, but something from my tuner car days jumped into my head. If you are running at 100% and not getting the height you need, change out one (or both) of your pulleys. A bigger pulley at the motor side, or a sm
Electronics Forum | Fri Jul 18 10:10:21 EDT 2014 | proceng1
We've got an MPM Accuflex printer that generally works great, but we've had a recurring problem. The powered rail (rear rail) fails to initialize. Sometimes all it takes is restarting the machine to get it to work. At the suggestion of the repair
Electronics Forum | Tue Oct 14 19:03:54 EDT 2008 | diesel_1t
currently we have a new Horizon 02i, new software "instinctive" is pretty easy to program and operator friendly, i love to work with proflow. Gridlock is not working so good as they told. I don't like that the paper doesn't roll while you're under cl
Electronics Forum | Fri Mar 13 15:09:20 EDT 2015 | marcelorotofrance
Hello everybody Lately our machine has been working pretty well, but it can’t last too long. Now, during this week’s production cycle, it began to increase the component’s reject rate to alarming levels (obviously the operators reported me when the m
Electronics Forum | Tue May 07 14:47:31 EDT 2013 | ngineer
Z axis seems to move as it should, the flag that goes through the C shaped sensor is not broken. I have gotten it to stay on everytime i start it up now (I did NOT change anything, just unplugged it for awhile, then plugged it back in an flipped the