Electronics Forum | Tue Sep 01 11:12:18 EDT 2015 | zombee
Problem is solved! There wasn't voltage on motor inputs (only 5-10V AC) when the motor connected correctly, but was ~210V AC without motor. Firstly, I exchanged the motor speed control relay (Panasonic G-series type), but the result was same. (the a
Electronics Forum | Mon Apr 08 15:39:10 EDT 2024 | mistrthou
The error is: MOT-Command/205: Motor speed out of control Motor speed deviates from expected speed. – Problem with power supply, motor current too low. – Mechanical problem, friction too high or tool stuck in Z. I'd be looking at excessive friction
Electronics Forum | Fri Nov 22 00:09:29 EST 2019 | mk15
I am looking for some help for where to look to fix this MY15E problem. 1. after hardware initiation appear - F-MOT-MOVE X/250: Motor speed out of control (photo1). 2. in service mode when x motor initiate appear - F-MOT-MSETDYN X/12: No axis movemen
Electronics Forum | Fri Feb 02 08:36:14 EST 2007 | CK Flip
Wow, I cut first cut my teeth in the Industrial motor control industry. My 1st company made motor control products like variable speed drives, solid state overload relays, soft starts, etc. and in our shop, we used nothing BUT Dow Corning silicone p
Electronics Forum | Fri Apr 16 10:34:29 EDT 2004 | kauer
A couple of questions for You. How old is this oven? Does it have a history of problems? When I have seen speed variations with our Omniflow 7s it is usualy the encoder but it usually spikes rather hard in one spot. You can see this physically and by
Electronics Forum | Tue Mar 05 09:11:11 EST 2019 | slayervv
The conveyor on our Topaz runs for about a second then stops. Turning on conveyor manually does the same thing. While conveyor is turned on manually, disconnecting and reconnecting 208AC at connection board starts the conveyor for a second then it
Electronics Forum | Wed Oct 03 23:42:32 EDT 2018 | gaintstar
SMT Reflow Oven Factory http://www.flason-smt.com/product/SMT-Reflow-Oven-Factory.html Introduction of SMT Reflow Oven Factory: 1. Windows XP platform, user friendly interface and easily swap between bilingual of English & Chinese. 2. Digital contr
Electronics Forum | Thu Jul 23 13:23:45 EDT 2020 | bmalhi
Small components blown issue could be due to one of the below. - Process issue; Make sure solder paste is fresh, if flux is drying out it will not hold parts properly. Check downward pressure of Pick Place. SOT may have to be pushed a little harder i
Electronics Forum | Fri Jan 10 00:56:53 EST 2003 | fastek
You really must be on a tight budget since most people will pay YOU to take these models off their hands. What is your budget for capital equipment? Zero? That said, I think you would be better served to step up a generation and look at MPA-3's inste
| 1 |
.gif)
winsouce.jpg)