Electronics Forum | Thu Aug 19 20:20:16 EDT 2021 | astarotf
Does anyone know why the heads of the GSM2 dual beam 4688 sound like this? When it is in x position the motor begins to vibrate
Electronics Forum | Tue Jun 14 15:59:25 EDT 2022 | mikevb
Thanks! I just needed a response like that. I will do all that, and if it's still an issue, I'll change the x wagon encoder right? There are three encoders on the x wagon though? The white one on the x carriage, the white one on the x belt drive mo
Electronics Forum | Wed Jun 15 19:46:15 EDT 2022 | mikevb
Hey All. I figured it out. It turns out that the problem was simply a loose coupler on the x wagon motor transducer. I had only checked one screw in the past but the other screw was apparently loose as well.
Electronics Forum | Fri Oct 28 10:58:26 EDT 2011 | emeto
Hi, 1. Lubricate X shafts or gears or whatever you have on the machine. 2. Clean X encoder 3. Change motor 4. Change card
Electronics Forum | Fri Oct 28 04:14:18 EDT 2011 | kenmar
I have a loud humming noise coming from my MY12 X-Motor ( Like when a motor is not locked in and it hunts). This noise is not all the time but only sometimes especially with fine placement!! What can it be? I do not want to change the Motor to find o
Electronics Forum | Fri Oct 28 13:27:58 EDT 2011 | kmakiya
Check to see if the mount precision is set to high in the package acceleration field. We set this to normal and the oscillation went away. I wonder if slowing down the x-axis would help.
Electronics Forum | Mon Oct 31 02:36:01 EDT 2011 | kenmar
Thanks , If you reduce the placement precision the X-Axis does not make any noise but than I had placement /pickup problems when it comes to Ic's.Slowing down did not make any difference.
Electronics Forum | Sun Jun 12 01:44:59 EDT 2022 | mikevb
I forgot to mention that I've measured and adjusted the cog play on the x axis and so it is within range, if that applies.
Electronics Forum | Sun Jun 12 01:38:47 EDT 2022 | mikevb
I'm having a problem with my Mydata My9 pick and place. Basically whenever I try to run the placement calibration program or try to have the machine find fiducials, or basically anything with precision, the machine displays a X MOT motor timeout erro
Electronics Forum | Sat Oct 29 14:33:34 EDT 2011 | tech1
Try swapping out the motor controller boards and see if the problem moves. More than likely it is the motor, coupling or the encoder. Some of the suggestions about reducing the acceleration in the package is a good idea but this will not provide a lo
winsouce.jpg)
.png)
