Electronics Forum | Wed Sep 04 20:29:56 EDT 2013 | saibot
We had that problem a few months ago with one of ours. Had to replace both y-axis motors and the tech said it's a common problem with the Opal-XII.
Electronics Forum | Wed Sep 04 11:37:30 EDT 2013 | trice1212
Afternoon SMTnet forum users, The Assembleon Opal-XII we use has been showing an error when ran at 100% speed. We talked to the tech in AZ and he believes we have a problem with our y-motors. We turned the speed down and haven't had the problem com
Electronics Forum | Mon Mar 25 11:37:25 EDT 2019 | alexcouto
Good afternoon KaHrpr, I understand that servo motors have a way of knowing how far they are. but how can I find out where to position the motor or how can I configure the motor to change its parameters? should I use any software that should be incor
Electronics Forum | Fri Mar 08 05:44:40 EST 2019 | bukas
are you sure #1 and #6 are interchangeable? if I remember correctly there is a catch with those motors, like there are 2 groups, group 1 being #1 #3 #5 and group 2 being #2 #4 and #6. maybe try getting it back and swapping cables at drivers for head
Electronics Forum | Fri Mar 22 13:32:15 EDT 2019 | kahrpr
all the motors on the head are the same just the connecting cable are different length. the motors have a home position for the zero pulse that home position has to match when the flag passes through the homing sensor all servos have a home position
Electronics Forum | Wed Mar 20 14:05:29 EDT 2019 | alexcouto
Hello again, I put the motors 1 and 6 back in their correct positions, but head 1 now gives me a new error. will it be necessary to configure the head 1 motor in any way? I was still checking to see if the belt and the engine would be in position, bu
Electronics Forum | Mon Mar 25 11:29:24 EDT 2019 | alexcouto
Good afternoon Bukas, Thanks for the help. As soon as I have news I communicate.
Electronics Forum | Fri Mar 08 04:03:34 EST 2019 | alexcouto
Hello guys, I am not very familiar with samsung cp 45 neo machines, however, I am trying to repair a head that from what I was told was always disabled. I activated head # 6 and there was no movement in the first phase, I thought it might be the fail
Electronics Forum | Fri Mar 08 04:08:39 EST 2019 | alexcouto
The video of the problem can be seen in the following link: https://meocloud.pt/link/5fd24217-3fe8-4e53-8ca3-7be8f04ca7fa/V_20190307_182529.mp4/
Electronics Forum | Fri Mar 08 07:26:38 EST 2019 | alexcouto
Good morning Bukas. Thanks for the help, I'll make that same change. I'll give you feedback later. Thank you very much
