Electronics Forum | Wed Nov 23 07:45:39 EST 2016 | bukas
hello, I have a GSM2 machine with faulty motor driver (i guess), usually when this error occurs i would rest it via button on a panel several times, but this time it doesnt work. what should i check/ measure to locate this problem? there is 7 blink
Electronics Forum | Fri Mar 08 05:44:40 EST 2019 | bukas
are you sure #1 and #6 are interchangeable? if I remember correctly there is a catch with those motors, like there are 2 groups, group 1 being #1 #3 #5 and group 2 being #2 #4 and #6. maybe try getting it back and swapping cables at drivers for head
Electronics Forum | Wed Sep 30 20:53:27 EDT 2020 | emeto
Motor and motor driver are involved in the equation as well.
Electronics Forum | Tue Jan 13 08:08:37 EST 2009 | leemeyer
I am assuming that the card that was changed was the motor driver card. Did they change the card with a known good board or just swap the X and Y cards. If they swapped cards it appears that the card that is now in the X motor slot is bad. Open the a
Electronics Forum | Thu Jan 19 07:43:54 EST 2023 | bukas
there is a special tool(cable) used to phase the motor with driver.
Electronics Forum | Wed May 19 09:32:28 EDT 2004 | Mr Fix it - MPM
Sounds to me like the driver for the tactile is not working. The tactile has three components to it. The first is the switch, the second is the pneumatic up/down actuator and the third is a small motor in the tactile assembly. The motor has a driv
Electronics Forum | Fri Mar 04 18:06:23 EST 2005 | alandra516
Having problems with a error (7x motor driver error) which happens everytime we turn on the 84VZ. Anybody out there had experiance with this is the past? Can you steer me in the right direction?
Electronics Forum | Tue Jan 13 09:50:36 EST 2009 | leemeyer
They also need to make sure that the switch settings are correct when changing cards. Each motor driver card has a different switch configuration depending on which slot it is installed in.
Electronics Forum | Fri Oct 27 21:39:48 EDT 2023 | sarason
Stepper motor drivers from Analog Devices? Send an email to Analog Devices and talk to a rep or go on the EEVBlog Forum and ask in https://www.eevblog.com/forum/beginners/ or https://www.eevblog.com/forum/projects/ regards sarason
Electronics Forum | Wed Dec 06 09:04:12 EST 2017 | dekhead
If you swapped in a different motor and had identical result then it isn't the motor. Suggest looking at driver or controller.
.gif)
