Electronics Forum | Fri Aug 14 07:52:03 EDT 2015 | mun4o
Hi all, 2 weeks ago we installing a new P&P machine - chip shooter.But , after installation proved that vibration of the new P&P arе very strong.If I use mashine to 100% of the speed the machine vibrating and after 2-3 panels moving 3-5 mm.The machin
Electronics Forum | Thu Jun 24 22:57:10 EDT 1999 | Cunli
Tom, Stan had posted a technical message to this Admin section. It has been moved to the SMT Forum per John's suggestion. If you are inviting SMTnet viewers to call you, please kindly state the reason they should do so, but it can not be for a com
Electronics Forum | Fri Sep 18 07:59:38 EDT 2015 | mun4o
Thanks FCM, we remove the metal plate and make a new ferro-concrete base.Under foot put ESD rubber.Now machine working perfect - without any vibration. Thank you very much and success.
Electronics Forum | Thu Aug 27 09:58:45 EDT 2015 | fcmtechnician
Hi Take out the steel plate, is acting like a trampoline, oscillating with the machine movements! Is the machine leveled OK? The installation guys use 0.02/1000 Spirit Level ( leveler )? Let the machine on the concrete floor, try first on the top o
Electronics Forum | Wed Feb 22 10:45:05 EST 2006 | Gilligan
FDA = Food and Drug Administration. Typically, the FDA requires a validation of every product that will ultimately go to consumers. The validation process is the basic "run it the same way with the same results" over a period of time. Back in my Phar
Electronics Forum | Tue May 16 02:12:58 EDT 2017 | robl
Hi Anthony, Hopefully some of the following may help: 1) Electrics - do you know the rating of each machine and the total load, and can your distribution box take it? Do you have the correct cabling and connectors in place to just plug the machines
Electronics Forum | Fri Nov 08 18:36:31 EST 2002 | leeloo
Nowadays I have a problem, I am in chsrge of the section of smt in my company, have a normal process inside my department with a minimal level of mistakes, the problem happens when the material is liberated to the lines of production on happened for
Electronics Forum | Mon Nov 11 11:42:26 EST 2002 | MikeF
Like Mark, I'm guessing your problem is with SMT parts on the top side, the solder is re-melting and some of the parts are moving around during when the board is being wave soldered. When I had some training on thru hole wave soldering way back when
Electronics Forum | Wed Sep 01 10:41:29 EDT 2004 | russ
Phil, you are incorrect on the value! You are right the 5 does signify the number of 0s to be 5, So when you move the decimal point 6 places to convert into uFarads from picoFarads you end up with .1, A 1uF cap has a 6 Russ
Electronics Forum | Fri May 07 05:01:09 EDT 2004 | ravi
hi friend, i am also from india, i will suggest you to contact to emst technologies pvt ltd. tel.no is --020-24332898/24330192. those people are having all types of m/cs. i think this is information is enough. all the best for new line.
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, 30 China
Phone: 0755-33578694
