Electronics Forum | Wed Apr 14 14:28:32 EDT 2021 | lpbro
My first move is inspect the blades, swap the blades around and re-balance the blades to see if it is a problem that corresponds with a specific blade. Also try a different pair of blades. Full restart on the printer incase of an odd software problem
Electronics Forum | Fri Nov 12 03:57:17 EST 2004 | pioneertechnology
Hi All For the past 8 years we have been screen printing paste succesfully using hard rubber blades. Over the past 12 months we have changed paste from lead to lead free, the board size has changed from 300x200mm to 120x90mm and we have also moved
Electronics Forum | Tue Nov 23 20:21:44 EST 1999 | Curtis T.
Does any one have any experience with the transition automation permalex squeegee blade (I called them and they couldn't tell me much), or any blade other than the typical nickle coated spring steel. Part of our production has been moved (by our cus
Electronics Forum | Sat Dec 16 14:08:32 EST 2006 | slthomas
"I did change blades and we did try another printer, problem still exists and it is across several different products but only that line." Not sure what that means since you reference "only that line" in the same phrase as "did try another printer".
Electronics Forum | Mon Feb 18 08:56:44 EST 2008 | operator
It does exist. We used to have one here, but sold it. It was more of a manual process though. You put the assembled board on the work table and then set your cutting blade height. Then you manually moved the cutting blade around shearing off the TH l
Electronics Forum | Wed Sep 20 22:19:06 EDT 2000 | Herman Koo
I am operating MPM AP HiE. The squeegee was just repaced with metal blade, side plastic deflectors(with spring) at both ends. The engineering dept suggested that we level the squeegee with the plastic deflector up. Afterwards, we loosen the screw and
Electronics Forum | Fri Mar 18 15:02:07 EST 2005 | pmd
Please clarify, Z axis gears (Blades)? The MPM head I believe is what your are asking is driven up and down via a lead screw. The machine gets the zero point from the "HAT" tactile sensor in the table nest. When squegees are installed the blades are
Electronics Forum | Thu Oct 26 20:32:08 EDT 2006 | foxhound
The squegee blades on the machine won't move down to level whenever I make a program. It has a standard head. I can jog them manually in calibrate mode but when I try to make a program they don't work. Why?
Electronics Forum | Fri Dec 15 07:37:07 EST 2006 | realchunks
Try changing blades. If still a problem, move job to another printer and cross feed to your existing line. If all else fails, try buying a new stencil. You could get new by Monday.
Electronics Forum | Wed Jun 19 11:26:06 EDT 2019 | key
We have been looking at the Sol for the in and out and the up and down for the blades. We moved the sol around with no change. where is the RS cylinder located in the DEK 248.
