Electronics Forum | Fri Apr 12 19:20:25 EDT 2013 | microaide
Some progress, now stuck again. I can now generate a pick and place program for two heads that actually runs the head 1 program when loaded into the central controller of machine #1. But all attempts at getting machine #2 to run the head 2 program ha
Electronics Forum | Sun Jul 05 22:21:58 EDT 2020 | raoult
Hi, The micro switch is broken on my device, it was a tactile one (4mm) : image1, image2 Do you think I can buy another one and just solder it like this with 2 wires (I can't solder it back to where it was because it's too tiny I don't have the sk
Electronics Forum | Mon Feb 05 10:12:32 EST 2007 | slthomas
The use of booties isn't required per se, just considered a standard step necessary to reach the 10,000 target. You also need to vacuum (central vac system, NOT exhausting into the room) daily, mop weekly, have a one piece floor, blah, blah, blah....
Electronics Forum | Tue Apr 30 10:29:42 EDT 2019 | spoiltforchoice
Well to some extent, but with QFNs, device manufacturers seem to have really gone to town with inventing new shapes and sizes. So while you could certainly generalize a bit with QFPs with common shapes like a TQPFP100 for instance; thats harder with
Electronics Forum | Thu Sep 11 10:01:30 EDT 2014 | spoiltforchoice
1 - Too messy, parts already come in nice easy to use machine compatible packaging, tapes, reels, tubes and trays. All you are doing is adding an extra step and complication. A key production aim is to reduce the number of steps. 2 - BGA - a chip wi
| 1 |
