Electronics Forum | Thu Feb 19 02:12:04 EST 1998 | Larry
HI, does anyone know where I can purchase used feeders for Panasert machines( MPA-G1, MPA-3F) or compatable? Thanks in advance.
Electronics Forum | Thu Feb 19 22:58:40 EST 1998 | George Henning
We have some extra feeders that are used on a MPA 10 and MPA 80. I don't know if they are compatible with the machines you mentioned. If you find that they are and have a list of requirements, I'll find out what we can provide you. Regards. | HI, do
Electronics Forum | Thu Feb 10 08:25:02 EST 2005 | marakas
Could anyone advise what BGA rework rate we should expect with product that has 4 BGAs (224 pins, 196 pins, 160 pins, 48 pins). Negative factor is that we have old and tired pick & place - Panasonic MPA-G1 or MPA-V without AOI.
Electronics Forum | Mon May 16 11:10:26 EDT 2005 | wizy
I look also for new job in SMT area. Machines what i know: MPM APHie paste printer Simens lines (S23, F5, HS60 etc.) Panasert lines (MV II F, MPA-V, MPA G1, HDP) Omniflow reflow soldering Macrotron and Baasel laser engraver PDT3000 PROM programer
Electronics Forum | Mon Apr 19 01:36:55 EDT 2010 | jola
Been a while since I used those machines but I found a list on how it was on ours anyway: MV2-F,C: F8-F1-F7-SHIFT-M-V MPA-V: F8-F1-F7-SHIFT-M-P-SHIFT-A-SHIFT-V MPA-G1: F8-F4-F7-SHIFT-M-F7-P-F7-SHIFT-A-F7 Always start from the main "run" screen. Go
Electronics Forum | Mon Mar 18 07:32:18 EDT 2013 | stephendo
It's been a long time but one thing I remember from those machines that about 50% of the time the error codes were a wild goose chase. At this point forget what the error code says. Can you move the head? Have you checked the servo cards? Is there
Electronics Forum | Mon Jun 12 22:35:57 EDT 2000 | Suan
Is there any tablets to reducce Dross Produced by the chemical reaction of the solder pot.If there is ,please recommend and to what extent is the % reduction do we expected to see. thank you Panas
Electronics Forum | Fri Mar 03 10:45:10 EST 2000 | PAI
We are dealing with a unique machine that is having a couple of problems that we are trying to fix. A component code error appears whenever editing is done to any part of the program, array, or component library. This error we believe is causing t
Electronics Forum | Fri Mar 03 10:45:10 EST 2000 | PAI
We are dealing with a unique machine that is having a couple of problems that we are trying to fix. A component code error appears whenever editing is done to any part of the program, array, or component library. This error we believe is causing t
Electronics Forum | Wed Jun 27 10:25:20 EDT 2007 | idabiga
Hi, I want to send / receieve data to/from our Panasonic P & P machines. I want to use VB6 or VB.net for the program and would like to know if anyone has the basic code for sending the data to the panasert or even some pointers on the best way to go
