Electronics Forum | Tue Oct 01 14:20:38 EDT 2013 | felo188
The problem was in the calibration of vision coordinates.
Electronics Forum | Mon Jul 29 03:49:16 EDT 2013 | felo188
Nobody has an idea how to deal with the problem?
Electronics Forum | Thu Jul 25 00:42:02 EDT 2013 | felo188
Hello everyone! I have problem with using vision in csm v60. Below describe: 1. Machine's third head takes one IC from tray 2. Goes to vision and take picture and moves IC 3. Goes to pick and place 4. When nozzle wants to place IC on board the
Electronics Forum | Wed May 25 05:21:43 EDT 2005 | ajaydoshi
Thanks, I will check & update. Checked Fan it is working fine. In this problem after power turn off if we start again their is no problem. Some time this problem occure at the start of day also ( no night shift production ) ajay
Electronics Forum | Sat May 21 07:23:38 EDT 2005 | ajaydoshi
We do face problem in CP643E, - Vision system alarm & later machine require to turn off. This problem ocurrs once in a week ( average ) Checked up Fuji along with trace data but could not able to get any solotion. Any recommondation. ajay doshi
Electronics Forum | Tue May 24 05:25:17 EDT 2005 | Zsolt
We had similar problem, the root cause was that the cooling fans on the VME rack were not working and the vision card hangs up if the temperature is too high. Also check the power supplies, we had also a problem that the filter condensator inside the
Electronics Forum | Mon Jul 28 17:13:28 EDT 2003 | Ryan Liao
Hello dear all: I have some problems with the CP642's vision process system . When the machine is working, sometimes the vision process system will appearance the error message. Error code :��1CA0A007�� Element code: FFFF Segment code: 0000 This s
Electronics Forum | Sun Nov 22 17:52:49 EST 2015 | wesleyintelli
Hi Deni, Thanks for your interest in my problem. It turned out that the power supply to the VGA vision board (the system in the black box)was faulty. I replaced it with a universal PC power supply and all is well.
Electronics Forum | Fri Jul 19 16:27:38 EDT 2013 | microaide
I think I have the vision problems figured out. There were two problems. 1) The Alignment type was set to "Small" for my TQFP48 part. It should have been set to "Complete". This is a clear case of poor documentation. The AutoProgram manual lists the
Electronics Forum | Mon Feb 17 02:51:21 EST 2003 | Scott B
We have also had this problem. I have managed to get around this by selecting a teach video model and positioning the teach window to include half the pad on the left and half the pad on the right so that the center point is bang in the middle of the
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
.gif)
