Electronics Forum | Sat Aug 15 20:20:37 EDT 2020 | ddfreeze
need the dimensions for a MPM#P2604 conveyor belt
Electronics Forum | Thu Mar 04 23:01:11 EST 2021 | tomek_k
P2604 BELT,CONVEYOR,.25" X105.25"L Regards Tomek
Electronics Forum | Tue Oct 14 19:03:54 EDT 2008 | diesel_1t
currently we have a new Horizon 02i, new software "instinctive" is pretty easy to program and operator friendly, i love to work with proflow. Gridlock is not working so good as they told. I don't like that the paper doesn't roll while you're under cl
Electronics Forum | Wed Sep 26 11:18:21 EDT 2012 | swag
You have to loosen the tension on both sides of the drive belt and skip a tooth or two until the cenveyor is parrallel. You'll have to grip the belt tight on one of the drive gears then force the other gear to rotate inside the belt on the other end
Electronics Forum | Tue Oct 09 11:42:42 EDT 2012 | cyber_wolf
Actually the correct way to fix this is to carefully remove the belt on the rear of the machine that connects the left and right rail lead screws together. Square the rails then carefully re-install the belt *without turning either of the lead screws
Electronics Forum | Mon Oct 08 13:31:50 EDT 2012 | highmillr
Yeah thanks swag, I do that ridiculous routine about every morning....im over it.... so I ordered a new belt..4 weeks lead time by the way from speedline. AND,...I took the tiny belt tensioners on each side and tightened both pretty tight and
Electronics Forum | Wed Sep 26 07:40:30 EDT 2012 | highmillr
I had this problem at another plant with the UP 2000....When the machine resets, The left and right side of the conveyor misaligns, causing the conveyor to be tight on the loading end and boards falling out of the unloading end. or vise versa...the t
Electronics Forum | Wed Jul 06 10:22:04 EDT 2005 | PWH
At times we have had this problem with our AP25 due to one of the conveyor belts slipping. Load a PCB and check to see that both conveyor belts are running at the same speed. If not, tighten the one that is dragging. Hope this helps.
Electronics Forum | Wed Dec 28 18:09:47 EST 2022 | atpico
Second question concerning MPM UP2000HiE: Are there two options of conveyor lengths for this printer? Looking for conveyor belts spare parts I found two options: One 137" and one 106" that gives about 134 and 174cm total conveyor lengths. Does any
Electronics Forum | Thu Jul 07 09:53:17 EDT 2005 | PWH
Agree with D.B. We have also had to replace the belt that runs the auto conveyor width function. It might look just fine, but it will skip teeth on occasion if stretched or worn. Reparallelling the conveyor rails can be done manually by skipping t
