Electronics Forum | Fri Mar 05 12:24:34 EST 2021 | astarotf
Hello Our problem was the camera that was bad, we replaced it and it worked again, greetings!
Electronics Forum | Thu Mar 04 22:38:54 EST 2021 | tomek_k
Hi Miałem taki problem, myślałem też że to uszkodzona karta Cognex. Zakupiłem nową i to nie pomogło. Okazało się że trzeba zainstalować właściwy sterownik karty. (translate from PL) regards Tomek
Electronics Forum | Mon Feb 10 08:18:18 EST 2020 | astarotf
Hi We have an Accuflex MPM with camera vision problems which shows no image, only the screen looks gray. With the diagram we show that our MPM camera is receiving the appropriate 12V voltage on pin # 6 of the camera and supplies the video output on p
Electronics Forum | Tue Jan 05 21:28:18 EST 2021 | rmitchell
We have an old MPM accuflex and both camera lights stopped working this morning during production. We tried the bulbs but the new ones did not work either. Any ideas on this? I don't think we have a manual but will keep looking in the dungeon. Plea
Electronics Forum | Mon Jan 11 17:19:31 EST 2021 | rmitchell
Problem resolved- The machine camera had crashed when the operator put the PCB in upside down (this was kept secret until intense water boarding). The crash seem to take out a chip on the vision processing PCB. It was visually damaged and looked lik
Electronics Forum | Wed Jan 06 22:10:04 EST 2021 | emeto
Measure if you have power where the light should go. Don't remember but it is probably 5V bulb/12V buld(it should say on it). if you have power, measure the bulb. I am not sure how new you new bulbs are.
Electronics Forum | Wed Feb 14 09:27:17 EST 2018 | cyber_wolf
On AP machines it is possible to mount the camera 180 degrees out. Not sure if this can happen on Accuflex.
Electronics Forum | Thu Feb 25 14:42:41 EST 2010 | vms
Hello would you want to sell it? Harry
Electronics Forum | Fri Oct 06 11:41:11 EDT 2006 | Bill
UP1500 was not a real MPM machine, so not relevant. UP1500 was an SMTech (UK) machine, different sofware, camera, etc.... than an MPM machine. AccuFlex is now real MPM.
Electronics Forum | Thu Aug 13 16:08:01 EDT 2015 | capse
I don't believe the lighting and camera have the same power supply. You have no image. The likely issue is the camera power supply of the camera itself.
.gif)