Electronics Forum | Thu Aug 13 16:08:01 EDT 2015 | capse
I don't believe the lighting and camera have the same power supply. You have no image. The likely issue is the camera power supply of the camera itself.
Electronics Forum | Thu Aug 13 14:52:42 EDT 2015 | deanott
We just encountered a problem with the vision on our MPM Accuflex. We just switched jobs and when we went through a 'Vision Set-up' there was no image (just blank gray screen where you'd normally see the PCB or bottom of stencil). When we tried to
Electronics Forum | Mon Jul 21 11:01:11 EDT 2014 | dontfeedphils
I dealt with the same issue for a month or so. We jumped through a lot of hoops, replaced both lead screws, verified the motor was good, a ton of stuff. Ended up being an intermittent wire connection between the control board and the conveyor width
Electronics Forum | Mon Jul 21 06:18:15 EDT 2014 | digar
We had this. The anti-backlash nuts were binding. > We took them apart, chased the threads with a tap > and re-assembled with slightly less pre-load. > Hasn't been a problem since. > We had this. The anti-backlash nuts were binding. > We took t
Electronics Forum | Thu Aug 13 19:54:01 EDT 2015 | aemery
The camera assembly is designated as X23; the stencil & board lighting as well as the camera video signal pass through the DB9 connector at the camera. There is a ribbon cable in the vision gantry tray that carries both to the box on the left side o
| 1 |
