Electronics Forum | Tue Feb 03 02:41:17 EST 2015 | vitrost
Hi, We have a snap-off issue. I guess it can be linked to z calibration.
Electronics Forum | Tue Feb 03 02:55:04 EST 2015 | max83
Hi, > > We have a snap-off issue. I guess it can > be linked to z calibration. > Hi, > > We have a snap-off issue. I guess it can > be linked to z calibration. > Hi, > > We have a snap-off issue. I guess it can > be linked to z calibration.
Electronics Forum | Thu Dec 01 13:35:21 EST 2016 | ttheis
I decided to replace the psu with three din supplies since it was a repeatable issue with the 5v rail. Machine is back in operation now with no signs of problems.
Electronics Forum | Wed Nov 30 20:43:06 EST 2016 | ttheis
OK, so went to power up again today and had the same kind of issues. The 24V and 5V lights on the cage flicker dimly about every 500ms. I tried my trick of disconnecting the +24v lead to the lift table amp and it acted the same, so it didn't work th
Electronics Forum | Tue Nov 29 11:45:35 EST 2016 | ttheis
I was able to repair the original power supply for the printer again with parts from another similar power supply on ebay. At first the machine didn't power up properly even though the supply voltages were all good on a volt meter when tested befor
Electronics Forum | Mon Dec 20 04:41:38 EST 2010 | accuspares
Hi, The input indicators can be located by selecting the 'Input' page located in the 'Diagnostics' drop down menu. Just select the Align tab at the top of the page and you'll be able to see when the nearly home and home sensors change state. The pr
Electronics Forum | Mon Dec 20 10:53:41 EST 2010 | remullis
I started swapping motor cables and sensor cable doing a process of elimination and never found a problem, I put everything back to original and it homed. I not sure if it was a connection issue or it was a sequence of homing the machine needs to do
Electronics Forum | Fri Dec 17 09:49:34 EST 2010 | remullis
Hello to all, I am having problems with the X,Y table initializing. I noticed the Skew motors 17M1 and 17m2 are moving but the table keeps wanting to drive in the left direction standing in front of machine. It will keep trying to drive until it tim
Electronics Forum | Thu Aug 13 16:08:01 EDT 2015 | capse
I don't believe the lighting and camera have the same power supply. You have no image. The likely issue is the camera power supply of the camera itself.
Electronics Forum | Thu Aug 13 14:52:42 EDT 2015 | deanott
We just encountered a problem with the vision on our MPM Accuflex. We just switched jobs and when we went through a 'Vision Set-up' there was no image (just blank gray screen where you'd normally see the PCB or bottom of stencil). When we tried to
