Electronics Forum | Mon Jun 12 23:52:58 EDT 2017 | aemery
Don, either you have a faulty park sensor or much more likely the vision gantry Y axis is not reaching the sensor. Possible issues, one of the two VY drivers cards is failing; one of the VY forcer motors (air bearings) is failing; to much air leakin
Electronics Forum | Wed Sep 26 11:42:19 EDT 2012 | comatose
I have an ap-25 and wish i had gotten the UP-2000 instead. How's that for an answer? The main difference is that the ap-25 uses linear motors and air bearings, whereas the up-2000 uses ball screws. The linear motors are faster, but the whole thing i
Electronics Forum | Wed Mar 25 11:16:35 EDT 2020 | richardcargill
Currently working through a myriad of air leaks on an old MPM Ap -b and have a question that hopefully one of you fine people may know the answer to. The camera vx and vy use linear rail motors. As far as I can tell, there are nozzles between the sur
Electronics Forum | Mon Sep 02 15:41:47 EDT 2013 | aemery
Mr Duckmann2000. Where is the leak??? Is it up on the dispenser behind the printhead? If so the simpliest thing to do, assuming you are not using the dispenser, is to cut the incoiming air tubing to the dispense pinch, fold it over and ty-wrap it.
Electronics Forum | Mon Jul 30 17:32:34 EDT 2007 | chrisgriffin
When you teach the "teach boardstop Y" make sure the camera is seeing the leading edge of the board and not too close to the rails. It should calculate the pre-stop position correctly. I assume you have thoroughly checked the sensor. Also check th
1 |