Electronics Forum | Tue Aug 16 22:51:06 EDT 2016 | aemery
Sorry I didn't catch your message sooner! 20k is way to much. The odds of you having 3 bad platens and 3 bad forcer motors would be very unlikely, unless the machine was sitting outside or something. If it is a 10 year old AP then I assume it must
Electronics Forum | Sat Jul 16 18:24:11 EDT 2016 | aemery
Scratches do not necessarily mean bad! Usually the forcer motor fails before a platen. The motors become weak or don't evenly distribute the supplied air, which causes them to tilt and drive into the platens. Mechanical misalignment of the VY forcer
Electronics Forum | Wed Jun 15 17:22:21 EDT 2011 | jorge_quijano
Hello, does anyone can help whith MPM AP Excel spare parts manual, I'm looking for Wiper system parts. Thanks!
Electronics Forum | Mon Sep 24 10:22:02 EDT 2012 | dontfeedphils
Looking for any input from those who may have used MPM's AP Excel model. How does it compare to printers you've used before? I've used Dek 256, and 03i machines as well as a couple of Accuflex models in the past, but never the Excel model. Thanks
Electronics Forum | Thu May 21 01:52:45 EDT 2015 | aemery
The AP-HIE came with paper manuals. I need to keep my paper manuals and don't have an extra, but the last model of the AP, the AP-Excel, came with manuals in PDF. I could burn a CD and send it to you. The machine use and operation is almost identi
Electronics Forum | Fri Jan 28 15:31:27 EST 2005 | valuems
Hello we have enough spares to build several AP20's. We sell MPM screen printers and spare parts. Glad to help harry
Electronics Forum | Fri Sep 20 12:32:46 EDT 2002 | cyber_wolf
Can anyone tell me where I might be able to find parts for the vision system on our AP25 printer. In particular I am looking for the cable(s) that go from the camera to the Cognex card. Thanks
Electronics Forum | Wed Dec 13 16:40:40 EST 2000 | Bill Fluegel
I am receiving a "cognex not found" error upon bootup of a MPM AP24-X stencil printer. I have checked everything I can find between the cognex computer and the one in the machine. Has anyone experienced this before? Any ideas would be greatly appr
Electronics Forum | Fri Oct 28 06:55:53 EDT 2005 | pavel_murtishev
Hello! I suspect that our MPM AP25 has separation problems (poor stencil � PCB separation). I observe a lot of �dog ears� after print stroke. And this is 100% machine problem, I�m sure. What machine parts should I check first time to avoid separatio
Electronics Forum | Fri Sep 20 15:44:00 EDT 2002 | pjc
Do you have a Panasonic & Toshiba camera? What are the MPM p/ns your looking at? Whats the problem? Noise perhaps. If noise try checking the metal cylinder to the right of the camara housing. The set screws can loosen up. Tighten up all the screws.