Electronics Forum | Sat Oct 15 19:18:14 EDT 2011 | enttec
Hi Does anyone have a calibration manual for a MPM AP25-Hie ? Have noticed recently that we have a slight mismatch between board and stencil when printing. I have the user manual but we didn't get calibration when we bought this machine Thanks Nic
Electronics Forum | Tue Oct 18 17:54:53 EDT 2011 | swag
Yea, it's tough and takes 25 disks. Not sure if there's a better way. As for NT, we bought NT upgrade packages from Speedline for all three of our AP25's. The backup is then done on a CD burner. I can't remember the cost of it all. However, be a
Electronics Forum | Mon Oct 17 16:24:10 EDT 2011 | enttec
Hi Thanks for the reply, which files contain this info ? I've searched around in the filesystem and can't find them
Electronics Forum | Tue Oct 18 17:38:03 EDT 2011 | enttec
Hi Thanks for the info, I'll try that. Can you tell me more about the NT conversion ? Our operators sometimes struggle with doing backups and such on the dos system Thanks
Electronics Forum | Mon Oct 17 10:14:32 EDT 2011 | swag
Do you have cal. fixture(s)? If not, one 1/2 baked way to get yourself closer quickly is to go into your programs and write down your x/y offsets that you've gained during vision offsets while in production. Compare them - hopefully they are very s
Electronics Forum | Tue Oct 18 10:07:59 EDT 2011 | swag
We converted all ours to NT so it's been a long time since I did config changes in DOS. Here's what I think I remember from when we had DOS O/S: Exit to DOS and type CD CONFIG in the command line. You should get a full list of configuration settin
Electronics Forum | Wed Sep 26 11:42:19 EDT 2012 | comatose
I have an ap-25 and wish i had gotten the UP-2000 instead. How's that for an answer? The main difference is that the ap-25 uses linear motors and air bearings, whereas the up-2000 uses ball screws. The linear motors are faster, but the whole thing i
Electronics Forum | Wed Sep 26 07:59:33 EDT 2012 | benreben
Hi, Someone can tell me what the difference in UP2000 and AP-25? What is the best machine? Thanks