Electronics Forum | Tue Apr 08 07:46:05 EDT 2008 | jdengler
Try all the used equipment dealers that advertise here. And post it in the Equipment Mart section. - Jerry
Electronics Forum | Wed Apr 16 06:03:11 EDT 2008 | lococost
hmm, DEK's just got up a notch on my preferred supplier list :)
Electronics Forum | Mon Sep 28 10:51:02 EDT 2009 | shanenaturalpoint
My company recently purchased an MPM AP27 on the used market. I had the machine up and functional at one point, but now it is inoperable. I have correct power and air to the machine, but when I attempt to power it up, I get nothing. Red light on t
Electronics Forum | Tue Apr 08 07:25:09 EDT 2008 | kevinjm
Hi all, Can anyone tell me where to get a motherboard for an AP27. I've tried speedline already but I'm being told we need to upgrade the whole pc which we find a bit too expensive. If anyone has any suggestions it would be much appreciated. Thanks
Electronics Forum | Tue Apr 08 09:30:35 EDT 2008 | kbyrne
Hi all, Can anyone tell me where to get a > motherboard for an AP27. I've tried speedline > already but I'm being told we need to upgrade the > whole pc which we find a bit too expensive. If > anyone has any suggestions it would be much > appre
Electronics Forum | Thu Jun 23 07:09:54 EDT 2005 | geb
Does anyone know why my MPM AP-27 machine would forget its fiducials? I make the program, save it, and then when I run the program it says it doesn't recognise the board even though I just taught it! Has anyone else had this type of problem or have a
Electronics Forum | Fri Apr 11 02:53:52 EDT 2008 | joseph_gonzales16
Hi I think much beter to go to upgarade PC because yo dont know the life time of second hand mothrer board if you buy an upgarde mohter baord ther is a warranty it is my suggestion. thanks i am a service of MPM printer and SPeedline oven and also wa
Electronics Forum | Tue Jan 24 10:48:52 EST 2006 | geb
Hi, We are starting to have supplied to us by customers different colour PCBs, which affects the ability of our MPM AP-27 stencil printer to see the fiducials. Has anyone tried and found out what the best and worst colours/ materials are for the fid
Electronics Forum | Wed May 30 21:16:05 EDT 2001 | davef
MPM AP-27 preferred over MPM AP-20 The issue is release of paste from the stencil. A vertical lift printer kinda snaps the stencil away from the board to complete the print cycle. The inertia and the rheometric properties of the paste make it rele
Electronics Forum | Wed Jun 22 09:19:45 EDT 2005 | geb
Don't have the manual (which is useful!) but suspect thats what the problem is. Anyone know where I could get a manual for an MPM Corporation AP-27 printer, can't find the company's website in Google.
