Electronics Forum | Tue Jan 08 16:25:00 EST 2013 | eduardo3mx
hello I need your help I have a machine mpm ultraprint3000 with the damaged hard drive I made a copy to the hard drive of another machine the same, but I have problems with the x-axis origin does not, either the track center, and the stencil wiper w
Electronics Forum | Thu Apr 26 13:16:28 EDT 2018 | bobpan
I am trying to figure out how to teach the position of the tooling so that its aligned to the hole in the worknest. In other words...the carousel is out of position. When i go into machine calibration and i step through it the process freezes at a st
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
Electronics Forum | Sat Apr 09 21:44:07 EDT 2005 | Marcel
Go in dos, go in the CONFIG dir. Edit the file ACCES.000 Yours passwords are there. You can delete the file and reboot, that will reset all passwords to factory default Operator MPM1 Maintenance MPM2 Supervisor MPM3 Calibrate MPM4 M
Electronics Forum | Wed Jan 22 08:59:40 EST 2020 | borisanic
I need to calibrate vision offset of MPM Accuflex printer. According to manual I need the calibration stencil with 49x49 holes. Does anybody know what is the approximately diameter of those holes and what is the distance between rows and columns?
Electronics Forum | Fri Jan 24 02:41:58 EST 2020 | borisanic
Thanks Phil. Is there any marks on calibration PCB or it is plain copper laminated PCB with dimensions 20"x20"?
Electronics Forum | Fri Jan 04 10:39:37 EST 2013 | dontfeedphils
We've got used MPM Accuflex that we recently purchased and it seems like the stencil to board offsets need to be calibrated. After looking into the manual it looks like it requires a fixture or calibration jig, can anyone confirm this? Does anyone
Electronics Forum | Wed Aug 04 21:46:13 EDT 2004 | simmcircuits
Hello Paul, Your Thru Bore calibration worked! Thanks a lot. Cheers, Fyodor
Electronics Forum | Thu Aug 05 02:27:17 EDT 2004 | fastek
So much for needing field service or calibration jigs huh? Congrats on fixing your problem.
