Electronics Forum | Tue Aug 15 02:45:14 EDT 2006 | dman97
Does anyone know if it is possible to lower the camera brightness when selecting fiducials? Our UP2020's camera is extremely bright and sometimes it causes the fiducials to be rejected cause they are too bright to be seen. Any settings than can be a
Electronics Forum | Tue Aug 15 12:02:55 EDT 2006 | pr
Check your gel flex. They're no good. Don't use em. good Luck pr
Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin
Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa
Electronics Forum | Tue Aug 15 07:31:27 EDT 2006 | Chunks
Yes, when teaching fids and you get to the screen shows your fid (either board or stencil), hit the middle "roller button" labeled NEXT. This will toggle your bulb from regular to bright and vice/versa. If it's still very bright, the bulb itself ma
Electronics Forum | Tue Aug 15 09:40:43 EDT 2006 | SWAG
Not sure about 2020 but AP's have an option to perform a histogram test/adjustment on the lighting. It's a black card, white card test and you can adjust a pot. in the machine to make the histogram curve "best-fit". On an AP, you find this option i
Electronics Forum | Fri Mar 05 12:24:34 EST 2021 | astarotf
Hello Our problem was the camera that was bad, we replaced it and it worked again, greetings!
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Mon Feb 10 08:18:18 EST 2020 | astarotf
Hi We have an Accuflex MPM with camera vision problems which shows no image, only the screen looks gray. With the diagram we show that our MPM camera is receiving the appropriate 12V voltage on pin # 6 of the camera and supplies the video output on p
Electronics Forum | Tue Feb 01 14:30:51 EST 2005 | johnw
Mail Altusgroup they are experts in this field www.altusgroup.biz
Electronics Forum | Fri Jan 28 15:31:27 EST 2005 | valuems
Hello we have enough spares to build several AP20's. We sell MPM screen printers and spare parts. Glad to help harry
