Electronics Forum | Fri Jun 12 14:19:03 EDT 2015 | tdemon69
i have a up 3000 ultraflex. the lower half of the tactile sensor is stuck down. i have replaced the driver board, check wire down to drive board,check the fuse for power on the driver board.
Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Thu Jul 02 17:06:39 EDT 2015 | aemery
Just to clarify, you are talking about the inner black box not driving down and not the pneumatic function that brings the tactile assembly closer to the stencil? Sometimes the pneumatic shafts get slightly bent and the assembly will not retract. T
Electronics Forum | Fri Aug 28 12:46:04 EDT 2020 | inspiredmorris20
Greetings all, my cp45 pnp machine is down this morning, gives me the code 0002 (front EME switch pressed). operator said they did not E-Stop, reset the unit and reboot the S/W a few times. the code pops up as soon as the software loads. I can turn
Electronics Forum | Fri Aug 28 17:24:28 EDT 2020 | stephendo
Did you check all the voltages and fuses? The second worst is when a machine is down for a while and it ends up being something basic. The worst is when it started as something basic and someone introduces a new problem. Also could there be any opti
Electronics Forum | Fri Oct 05 11:59:54 EDT 2001 | mparker
I am looking to learn of possible causes and solutions for the following problem. A potential customer is demanding that I use a saponifier in the aqueous wash, he has lab test results of former CM's products that leads him to believe it is necessar
Electronics Forum | Tue Dec 29 17:42:27 EST 1998 | Dave F
| Can anyone recommend a solder stop that can be applied by our PCB supplier. Our current material form Tamura Kaken is causing problems. | | The material should be capable of withstanding 1 Surface mount IR reflow cycle and 1 wave solder cycle. | W
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Tue Aug 02 11:17:27 EDT 2005 | Stefan
Tape feeders usually have a fixed pick position regardless of the package size. Is the component body off center in the tape pocket? I hope you can enter an offset in the feeder set up file. Also, perforation holes can deform, if the reel is too hea
Electronics Forum | Mon Jul 18 21:36:18 EDT 2022 | ttheis
We have two GSM machines (4-spindle, single beam) and had a camera fail on one machine. We decided to clean and calibrate the cameras on both machines. One machine we had no problems and all is working properly. The other machine will not pick up the
winsouce.jpg)