Electronics Forum | Thu Aug 05 02:27:17 EDT 2004 | fastek
So much for needing field service or calibration jigs huh? Congrats on fixing your problem.
Electronics Forum | Wed Jul 21 01:27:17 EDT 2004 | simmcircuits
Hi, I need help in aligning the stencil and the board on an MPM AP25. I have no calib jig and stencil what I did was edit w/dos editor the file ap.cal. It seems to be working OK now just a little bit of offset but what I'm concerned is the software t
Electronics Forum | Fri Jan 04 10:39:37 EST 2013 | dontfeedphils
We've got used MPM Accuflex that we recently purchased and it seems like the stencil to board offsets need to be calibrated. After looking into the manual it looks like it requires a fixture or calibration jig, can anyone confirm this? Does anyone
Electronics Forum | Tue Jul 27 19:02:46 EDT 2004 | pdeuel
Not an easy task and requires calibration jig. MPM support field service is your best bet. The adjustment screws for the prizm located on left side of camera will adjust the x direction. There is a set screw on the front that must be loosened first.
Electronics Forum | Fri Jan 04 13:47:00 EST 2013 | cyber_wolf
If its the same as a Momentum then no you do not need to use jigs. There is a "global offset" field that allows you to add background offsets. The glass plate jig calibration procedure only needs to be used after a major crash or if you feel the need
Electronics Forum | Mon Sep 25 12:50:42 EDT 2006 | chris g
Daxman, The diagnostic results didn't look very pretty. Especially on the vision x standard deviation. Any time there is an asterisk, that is a bad thing. The failure number for all axis, excetp theta, is .0002. Could need more air flow to the x
Electronics Forum | Wed Feb 25 22:32:39 EST 2009 | exsydeco
the company name is similar to my screen name. you will be smart enough to notice it, it is in forli, italy. machines that i service is Yamaha/Philips. He sells feeders too, but junk feeders that he take for free (thats what he said) from customers
| 1 |
