Electronics Forum | Mon Aug 19 06:27:18 EDT 2019 | carryjhn
This is due to the corrupted Drivers, you must update it for the flexible work. As electrical issue causes damage to its AC transformer, https://www.printersrepairnearme.com/blog/fixed-the-issue-hp-printer-not-activated-error-code-30/ helped me to kn
Electronics Forum | Thu Nov 11 22:01:11 EST 2004 | Ken
Relay: Yes, you can drive a "DC" relay with AC. As long as the latching threshold is achieved, you can close the contacts. However, if the relay impedence is improperly selected, relay chatter can occur. I am confident MPM selected a correct rela
Electronics Forum | Thu Nov 11 17:49:11 EST 2004 | pdeuel
We are having a problem with our AP-24x printer. When the vacuum motor spins up we get a 60 hz buzz into the DC drivers for the forcers and the stencle wiper. We also indicate a main power drop from 115 vac to 80 vac. The vacuum motor checks out good
Electronics Forum | Sun Nov 27 16:53:39 EST 2016 | ttheis
Our UP500 has been running great for a few months then the AC/DC 5/12/24V power supply stopped working and the PC could not communicate with the cage. The PC screen also got very noisy. We replaced the power supply with a used replacement and the ma
Electronics Forum | Mon Sep 28 14:02:15 EDT 2009 | swag
As mentioned previous, check all fuses & breakers. In the AC chassis (should be under black cover beind front, right door), remove cover and check main circuit breaker. Also should be two fuse housings next to breaker - if they are lit up amber, th
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Wed Jul 21 10:05:22 EDT 1999 | Mark Quealy
| | | I recently switched from solder paste in 500 gram jars to 500 gram tubes. I did this to try to limit the time the paste is exposed to the room environment. But we have a need to clean the stencil every 4 - 5 boards which means taking the bulk p
Electronics Forum | Thu May 11 04:23:50 EDT 2000 | Earl Moon
Hey folks, I'm on your side, as I said many times in this string. To end it, from my point of view, I will offer the following diatribe with which I responded to one of you whom I respect very much - Dave F. This is my last say on the subject and I
Electronics Forum | Wed Jul 21 11:49:24 EDT 1999 | Deon Nungaray
| | | | I recently switched from solder paste in 500 gram jars to 500 gram tubes. I did this to try to limit the time the paste is exposed to the room environment. But we have a need to clean the stencil every 4 - 5 boards which means taking the bulk
| 1 |
