Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Tue Aug 15 07:31:27 EDT 2006 | Chunks
Yes, when teaching fids and you get to the screen shows your fid (either board or stencil), hit the middle "roller button" labeled NEXT. This will toggle your bulb from regular to bright and vice/versa. If it's still very bright, the bulb itself ma
Electronics Forum | Tue May 04 10:53:18 EDT 2004 | Mike
You can call MPM technical support at 800-737-8110. They should be able to help.
Electronics Forum | Tue May 04 10:51:29 EDT 2004 | Mike
Call MPM technical support at 800-737-8110. They should be able to help you out.
Electronics Forum | Mon Jun 04 14:06:13 EDT 2012 | cyber_wolf
These guys may be able to help. http://www.cardinalcircuit.com/
Electronics Forum | Mon Mar 05 23:41:23 EST 2018 | 3l3ctro
Would like to know if you were able to resolve this issue?
Electronics Forum | Tue Oct 18 11:13:52 EDT 2005 | fastek
MPM/Speedline will sell you a complete set of manuals in hardcopy or CD. Cost is $500-$750. Since you bought the machine used and likely very cheap you should be able to afford that. Talk to your local rep. in HK.
Electronics Forum | Mon Jan 07 08:23:37 EST 2013 | cyber_wolf
You should be able to find this in the utilities menu under calibrate machine. (If your software is the same as my Momentum) If not, give MPM service a ring. They will help you.
Electronics Forum | Wed May 23 19:29:41 EDT 2018 | mattkehoe
IT WORKED! Thanks for the feedback. Between your confirmation and my feeble memory I was able to make the adjustments and the MPM is running like new! Thanks SMT Net!
Electronics Forum | Wed Mar 31 04:43:52 EDT 2010 | accuspares
If you dissconnect the crash beam sensor one at a time at the front leaving the remaining one connected you’ll be able to identify what side is causing the problem. Then you will be able to hopefully remove the object or adjust the position of the be
