Electronics Forum | Tue Oct 23 09:21:44 EDT 2018 | bobpan
What files should we backup in case of a hard drive failure on the momentum printer? Software is 3.6.1. Thanks
Electronics Forum | Thu Apr 26 13:16:28 EDT 2018 | bobpan
I am trying to figure out how to teach the position of the tooling so that its aligned to the hole in the worknest. In other words...the carousel is out of position. When i go into machine calibration and i step through it the process freezes at a st
Electronics Forum | Fri Dec 14 19:56:40 EST 2018 | denisss
Good afternoon, the problem gives an error vision gantry x, an error occurs after the camera approaches the car wash and hits the piston, what could be the matter? are there any real specialists gives an error after a certain working time of 40 minut
Electronics Forum | Tue Aug 15 02:45:14 EDT 2006 | dman97
Does anyone know if it is possible to lower the camera brightness when selecting fiducials? Our UP2020's camera is extremely bright and sometimes it causes the fiducials to be rejected cause they are too bright to be seen. Any settings than can be a
Electronics Forum | Fri Aug 26 05:18:05 EDT 2016 | ariss_t
Hi, anybody facing the vision 'off' error when using MPM Momentum ?? i change the purple vision cable but still facing the same issue.. the image go black when camera moving for searching fiducial.. any ideas ??
Electronics Forum | Mon May 13 13:45:33 EDT 2019 | whitelancer64
I am having the same problem with the MPM Accela solder paste printer machine. If the fiducials are adjusted for PCB alignment, the location of the paste is then wrong, and vision inspection fails. This is a problem for both pad preview inspection
Electronics Forum | Wed Mar 27 13:47:24 EDT 2019 | whitelancer64
I am having an issue with aligning vision for solder paste inspection with the PCB in the Momentum machine. The SMT operators setup the profile on the machine, which I then import into Aegis CircuitCAM to add PCB locations. But when I export again, t
Electronics Forum | Fri Mar 29 16:57:07 EDT 2013 | aemery
Gentlemen, Just became a member and scanning the old posts hoping to help people out with their MPM printers. Most of this info is correct, the last post was the best. Offsets on an Accuflex printer can be put in either per process program or glob
Electronics Forum | Sun Aug 28 23:53:58 EDT 2016 | aemery
I don't think there is a camera off message in the software, but I might be wrong. So I am making a bit of an assumption here that you didn't have a displayed image and your error was a fiducial not found error. I am also wondering if you decided to
Electronics Forum | Wed Sep 07 14:14:17 EDT 2022 | axelaspeed
We recently purchased a used MPM Momentum Compact and can't log in using the supplied login and password. Is there a default (admin) login I can use to bypass this?
