Electronics Forum | Tue Oct 23 09:21:44 EDT 2018 | bobpan
What files should we backup in case of a hard drive failure on the momentum printer? Software is 3.6.1. Thanks
Electronics Forum | Thu Apr 26 13:16:28 EDT 2018 | bobpan
I am trying to figure out how to teach the position of the tooling so that its aligned to the hole in the worknest. In other words...the carousel is out of position. When i go into machine calibration and i step through it the process freezes at a st
Electronics Forum | Wed Dec 06 23:54:24 EST 2006 | valuems
Think you will find every mpm is operating on dos base software, just in the last 2 years have they got software with windows base. The mouse is related to the version of software, and the old software requires only one model of mouse. Give up tryi
Electronics Forum | Fri Dec 14 19:56:40 EST 2018 | denisss
Good afternoon, the problem gives an error vision gantry x, an error occurs after the camera approaches the car wash and hits the piston, what could be the matter? are there any real specialists gives an error after a certain working time of 40 minut
Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Fri Apr 26 08:04:59 EDT 2019 | griinder
We solved the issue. A stencil must be clamped in the machine to allow the command. The stencil serves to hold the board level, while the pins are set. The machine is smarter than us.... :/
Electronics Forum | Wed Apr 24 13:49:19 EDT 2019 | griinder
I have a support question concerning setting the gridlock tooling in manual mode on a MPM Momentum Elite. I am printing the top side (bottom is populated with parts) of a thin, flimsy PCB. The Grid lock tooling bows the PCB upwards in Auto mode, beca
Electronics Forum | Fri Aug 26 05:18:05 EDT 2016 | ariss_t
Hi, anybody facing the vision 'off' error when using MPM Momentum ?? i change the purple vision cable but still facing the same issue.. the image go black when camera moving for searching fiducial.. any ideas ??
Electronics Forum | Wed Sep 07 14:14:17 EDT 2022 | axelaspeed
We recently purchased a used MPM Momentum Compact and can't log in using the supplied login and password. Is there a default (admin) login I can use to bypass this?
Electronics Forum | Mon May 09 21:07:53 EDT 2022 | kurtiss
Currently we have a line running a MPM Accuflex. We are working on setting up a second production line and are in need of a new stencil printer. The two machines available within budget are a MPM Momentum and a Ekra X6. We have been happy with the MP
winsouce.jpg)
.gif)
