Electronics Forum | Mon Jan 15 20:03:09 EST 2024 | griinder
Does anyone have experience of using a stainless Fine Grain SMT stencil for the purposes of applying ink to bare PCB's? We are exploring the possibility of getting a stencil to apply a letter that reflects the revision to each of 25 PCB's in a panel.
Electronics Forum | Tue Nov 25 12:48:31 EST 2014 | cyber_wolf
Has anyone looked at SPI results across different squeegee blade manufacturers ? We are running Momentums and using the MPM pro-blades. Ive been considering looking at permalex blades again to see if I can maybe squeek out some better yields.
Electronics Forum | Wed Oct 07 16:00:01 EDT 2020 | lpbro
Using MPM Momentums, I like choosing blades that allow about an inch of overhang on each side of the board. I feel it allows me to dial the squeegee pressure a bit better.
Electronics Forum | Thu Aug 07 09:24:42 EDT 2014 | tombstonesmt
Good morning everyone! I'm searching through tech sheets and equipment manuals to determine the recommended paste thickness on the stencil during operation. We use a MPM momentum screen printer using SAC305 paste. Board isn't too complex; one QFP, co
Electronics Forum | Wed Apr 21 13:52:34 EDT 1999 | Steve Gregory
Technically speaking, there is nothing for me to say. Oh maybe just one thing - to get me back into the fray: Steve, I must say I totally disagree with your assessment of under screen cleaners. I have had nothing but excellent results using the dry,
Electronics Forum | Wed Apr 21 18:58:44 EDT 1999 | Earl Moon
| Technically speaking, there is nothing for me to say. Oh maybe just one thing - to get me back into the fray: Steve, I must say I totally disagree with your assessment of under screen cleaners. I have had nothing but excellent results using the dr
| 1 |
