Electronics Forum | Tue Oct 23 09:21:44 EDT 2018 | bobpan
What files should we backup in case of a hard drive failure on the momentum printer? Software is 3.6.1. Thanks
Electronics Forum | Thu Apr 26 13:16:28 EDT 2018 | bobpan
I am trying to figure out how to teach the position of the tooling so that its aligned to the hole in the worknest. In other words...the carousel is out of position. When i go into machine calibration and i step through it the process freezes at a st
Electronics Forum | Fri Dec 14 19:56:40 EST 2018 | denisss
Good afternoon, the problem gives an error vision gantry x, an error occurs after the camera approaches the car wash and hits the piston, what could be the matter? are there any real specialists gives an error after a certain working time of 40 minut
Electronics Forum | Wed Jun 13 12:08:22 EDT 2001 | vance
What kind of quality improvements could be expected by implementing MPM's Rheopump instead of using squeegee blades on a stencil printer?
Electronics Forum | Thu Jun 14 16:33:32 EDT 2001 | pr
I have found all the advantages (that others have spoken about) are true. One thing to look at is the quick disconnect system that MPM offers which will reduce changeover times to almost the same as blades. It's well designed and so far, for us, has
Electronics Forum | Tue Apr 06 10:30:48 EDT 1999 | Scott Davies
Tony Although I agree in principle with Dean that 45 Degrees would be ideal, most of the squeegees I have worked with have been 60 Degrees to the stencil surface. This seems to work best with metal squeegees when printing HASL boards, because the sl
Electronics Forum | Fri Jun 29 13:54:43 EDT 2001 | Brian W.
I have had some conversations with MPM about the Rheo pump. They have some data to support the change from an ROI standpoint. One of their customers has seen a dramatic decline in the amount of wasted paste, resulting in a very large cost savings.
Electronics Forum | Wed Apr 07 11:42:16 EDT 1999 | Tony A
| Tony | | Although I agree in principle with Dean that 45 Degrees would be ideal, most of the squeegees I have worked with have been 60 Degrees to the stencil surface. This seems to work best with metal squeegees when printing HASL boards, because
Electronics Forum | Wed Jun 13 21:25:48 EDT 2001 | dougk
We've tried the MPM rheo., with excellent results. We saw a decrease in fine-pitch pad coverage rejects from ~20% to bacicially ~0%. Print speeds went from 1-2 in/sec (metal blade) to 4-5 in/sec (rheo.). Could probably go faster. Great throughput. Li
Electronics Forum | Thu Jun 16 20:29:12 EDT 2011 | dman97
Does anyone know if it is possible to change the distance that the squeegees travel? What i mean is... Is it possible to change where the squeegees start and stop during a print? Our squegees seem to stop right at the edge of the apertures and this
winsouce.jpg)