Electronics Forum | Sun Jun 25 23:42:57 EDT 2006 | dman97
OK guys, thanks for your help. I got everything setup back to the way it was. You guys were very helpful.
Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Sun Feb 13 20:12:53 EST 2000 | K. S. PARK
Hello . i am reviewing the s/p dek (dek 265 infinite) ,mpm (up3000). all user say the machines are good. but to me rheopump versus proflow. which one is better. someone out there using these head advise me. bad or good thing whatever it is
Electronics Forum | Thu Jul 27 22:27:45 EDT 2006 | seth
Vision X-Y maintenance procedure, please advise. I have problem with camera not park so often time, and I don't have any solution accept buying a new vision Y right stepper motor, but that's just too much money roughly 2500 dollars.
Electronics Forum | Tue Aug 01 18:12:18 EDT 2006 | SWAG
Check to make sure the platen and the camera are meeting the sensors that tell the machine they are "parked". Find these sensors and flag them. Look for indication they are working in the input screen. Also, make sure the sensor flags can go into
Electronics Forum | Tue Aug 01 22:33:36 EDT 2006 | seth
Let me ask you another question. Could this happen if either vision Y left or right not sync together? I checked the vision air regulator Left and Right it is set at 70 psi. My print is not being consistance, and I have to turn all my inspection off
Electronics Forum | Tue Nov 08 10:52:29 EST 2016 | aemery
Tom, Hardware limit means the machine thinks it is at the limit sensor or a particular axis timed out before it got to the home sensor during the reset sequence. Go to your O/I map and see if any of the axis limit sensors are lit. You could have a
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Fri Oct 04 14:15:21 EDT 2019 | ddfreeze
that doesn't seem to be the issue here