Electronics Forum | Thu Dec 29 18:51:16 EST 2022 | compit
Standard 51" (1295.4mm) Optional 66" (1676.4mm)
Electronics Forum | Tue Aug 29 21:14:45 EDT 2006 | Bubba
You need a machine with side clamps. DEK makes them. MPM makes them. Look into a retro for your machine. Both take up space on top of your board. Be carefull of top side component clerance if switching.
Electronics Forum | Mon Aug 28 12:07:15 EDT 2006 | cyber_wolf
We are looking into purchasing a used UP-2000 Hi-e. We are high mix /high change-over. The machines I am looking at are equipped with the grid-lok system. Can anyone give me pros's/ con's ?? Thanks in advance. Sr.
Electronics Forum | Sat Sep 02 07:38:43 EDT 2006 | cyber_wolf
We have decided to go with a UP2000 Hi-e with the newer generation Grid lok. This is a refurbed machine with a warranty.
Electronics Forum | Thu Dec 29 18:44:36 EST 2022 | compit
Yes, there are two lengths. My MPM UltraPrint 2000 HiE has trays protruding from the machine about 15 cm, I think. I'll check with the company tomorrow to see if there are any numbers in the manual. I have a link to the part saved - maybe check it ou
Electronics Forum | Mon Sep 04 16:07:38 EDT 2006 | C.K.
Grid Loks & Gels ain't my forte, but when it comes to JNJ Support Plates for the MPM, (http://www.jnj-ndustries.com/PDFFiles/Techno%20Talk/Vol.%20VI%20-%20WEB%202003.pdf) and Quantum Physics....I'm your man.
Electronics Forum | Thu Aug 13 19:51:47 EDT 2009 | prasadz
Jagadeesh Rajagopalan is the expert in MPM Screen printer Servicing and he suggest to do the calibration of Z axis with PCB thickness (1.3mm)
Electronics Forum | Thu Jul 25 20:47:13 EDT 2002 | Dreamsniper
Thanks for that info... I found out that MPM has UP2000 HiE VP with price lower than DEK Horizon but just a bit higher or let's say relatively the same as DEK ELA...I find it hard to decide which among the 2 based on our budget capability. My budget
Electronics Forum | Mon Apr 28 21:51:56 EDT 2014 | elabcircuits
Hello, We have a MPM UP2000 HiE printer from 2000, software version 7.2E. The PC board is not booting anymore (black screen), no drives spinning. It's an Advantech 486SX version. Question: would a Pentium 3 SBC (Single Board Computer) with ISA
Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135
When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an