Electronics Forum | Mon Feb 22 10:19:57 EST 2010 | swag
Check/reseat all connections on axis driver card and from driver card to step motor. On older MpM's it is common to get a bad connection on the connector for axis driver power and blow components on your driver board. Reseating these connectors mig
Electronics Forum | Wed Nov 26 18:17:26 EST 2014 | rhcriad
Thanks SWAG. I will clean up all of the connectors, reseat and hope for the best!
Electronics Forum | Thu Sep 24 07:18:27 EDT 2015 | anilwagh
Check all axis driver card,input supply connector may burn.
Electronics Forum | Tue Nov 25 18:39:59 EST 2014 | rhcriad
We have an MPM UP2000 stencil printer and have a lot of issues with burned out 6410 driver cards (or driver cards just failing to work). I have looked over these threads and found that this is a common issue with these cards. I understand that thes
Electronics Forum | Wed Nov 26 10:10:13 EST 2014 | swag
Reseat all the connectors on the cards make sure pins are clean and no corrosion. Not sure what to say about current, etc. There is or was a place on the east coast that repairs these cards. Can't remember who it is - sorry not much help with that
Electronics Forum | Wed Oct 20 11:14:55 EDT 2010 | swag
I hope you're fixed by now but my advice is to pull all connectors from drivers and reseat. Also, reseat connectors in I/O area + I think there's some cards that relay power to various axis in this area. Reseat all connectors. From my experience,
Electronics Forum | Wed Feb 20 15:21:56 EST 2013 | rmitchell
Hi, hopefully I am too late, it is fixed and you are up and running. Have you tried MPM support on the phone? We have 2 older MPM's and the blow the driver modules in the bottom drawer on the back of the machine. There are different drivers for dif
Electronics Forum | Sat Jul 19 19:23:48 EDT 2008 | proy
We got it working; We replaced the old video card with an older ISA video card to get the display to work. Then we removed the ELO touchpanel ISA card, which cleared an IRQ conflict with the mouse on COM 1. Running mouse drivers AND VGASPM.EXE fro
Electronics Forum | Thu Feb 21 08:20:43 EST 2013 | cowens
Thank you so much. We actually did get the machine up and running yesterday morning. We switched the theta and the transport driver cards and it is working now. We have had the connectors burn on us in the past and replaced them. I am hoping the prob
Electronics Forum | Fri Mar 29 16:17:47 EDT 2013 | aemery
Sorry I am late on this thread, just became a member and was scanning through the posts. I am a former FSE for Speedline, now independant, so all this stuff is my bread and butter. Here are some facts that could help you all in the future. MPM pri
