Electronics Forum | Wed Jul 05 17:37:46 EDT 2017 | tobytoby292
I have a UP-100 screen printer that was locking up on me by removing my cursor and not allowing any button presses. I did a hard reset and this fixed it temporarily i now have encountered a new problem where the unit displays a "communication error""
Electronics Forum | Fri Dec 14 19:56:40 EST 2018 | denisss
Good afternoon, the problem gives an error vision gantry x, an error occurs after the camera approaches the car wash and hits the piston, what could be the matter? are there any real specialists gives an error after a certain working time of 40 minut
Electronics Forum | Tue May 04 16:04:40 EDT 2004 | Kuru
Your are right my trackball was the problem, Now it resets and error on Tactile sensor. If anyone knows where I could get used parts beside MPM, please let know. Thanks
Electronics Forum | Thu May 13 16:54:55 EDT 2004 | Kuru
I just installed a used Tactile sensor unit, Now it now reads error "Tactile Sensor sensor never closed". If anyone knows or seen this problem pls help. I have adjusted the flag on the photosensor.The photosensor appear to be functioning but the step
Electronics Forum | Fri May 14 12:40:03 EDT 2004 | Kuru
My switch is good, I can check the switch and the two photo sensors on the input test screen. They are turning on and off.I can see it no the board too. When I start up I can see Tactile unit come down so I know pneumatics portion is good. I am still
Electronics Forum | Wed Jan 13 20:44:42 EST 1999 | Steve Gregory
Hello Sanjay! The cheap deal I use that Earl spoke of is called a SMarT Measure. It's a depth measuring microscope that uses the same principle of measuring optical focus that the units from Vision Engineering do ( if you've ever looked at any
Electronics Forum | Thu Jan 14 11:08:29 EST 1999 | Mike McMonagle
Steve, Whoa, take a breath! That was at least a dollar three-eighty answer. I've got to agree that nothing can replace a qualified, concientious operator for assuring quality. When I too worked at a small shop there in SillyCone Valley, my seni
Electronics Forum | Thu Jan 14 15:22:14 EST 1999 | Earl Moon
| Steve, | Whoa, take a breath! That was at least a dollar three-eighty answer. I've got to agree that nothing can replace a qualified, concientious operator for assuring quality. When I too worked at a small shop there in SillyCone Valley, my
Electronics Forum | Sat Jun 21 11:00:32 EDT 2008 | 1036
We recently bought an used MPM SPM screen printer. The system can not boot up correctly and terminates the program finally. During the computer booting up, I can see error massages "mouse could not be found", "abnormal program terminated", "trap 0".
Electronics Forum | Wed Feb 27 20:49:36 EST 2019 | gonzalo12
Hi I have this communication error on a MPM Acuflex screen printer machine, it power up loads software but when it tries to Zero, it shows a communication error on the screen. Have anybody seen this error?
