Electronics Forum | Wed Jul 05 17:37:46 EDT 2017 | tobytoby292
I have a UP-100 screen printer that was locking up on me by removing my cursor and not allowing any button presses. I did a hard reset and this fixed it temporarily i now have encountered a new problem where the unit displays a "communication error""
Electronics Forum | Fri Dec 14 19:56:40 EST 2018 | denisss
Good afternoon, the problem gives an error vision gantry x, an error occurs after the camera approaches the car wash and hits the piston, what could be the matter? are there any real specialists gives an error after a certain working time of 40 minut
Electronics Forum | Wed Apr 18 00:49:13 EDT 2018 | mohsenpour
hello my printer is mpm up2000 software on windows nt4 not working i want soft(apnt.exe) or image for this machine
Electronics Forum | Tue Jan 08 16:25:00 EST 2013 | eduardo3mx
hello I need your help I have a machine mpm ultraprint3000 with the damaged hard drive I made a copy to the hard drive of another machine the same, but I have problems with the x-axis origin does not, either the track center, and the stencil wiper w
Electronics Forum | Tue Aug 15 02:45:14 EDT 2006 | dman97
Does anyone know if it is possible to lower the camera brightness when selecting fiducials? Our UP2020's camera is extremely bright and sometimes it causes the fiducials to be rejected cause they are too bright to be seen. Any settings than can be a
Electronics Forum | Tue Aug 15 12:02:55 EDT 2006 | pr
Check your gel flex. They're no good. Don't use em. good Luck pr
Electronics Forum | Tue Aug 15 09:40:43 EDT 2006 | SWAG
Not sure about 2020 but AP's have an option to perform a histogram test/adjustment on the lighting. It's a black card, white card test and you can adjust a pot. in the machine to make the histogram curve "best-fit". On an AP, you find this option i
Electronics Forum | Tue Aug 15 07:31:27 EDT 2006 | Chunks
Yes, when teaching fids and you get to the screen shows your fid (either board or stencil), hit the middle "roller button" labeled NEXT. This will toggle your bulb from regular to bright and vice/versa. If it's still very bright, the bulb itself ma
Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin
Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa
Electronics Forum | Tue Oct 23 09:21:44 EDT 2018 | bobpan
What files should we backup in case of a hard drive failure on the momentum printer? Software is 3.6.1. Thanks
.gif)
.gif)
