Electronics Forum | Tue Mar 18 11:52:38 EDT 2008 | rrpowers
A couple years back we were looking at going to an enclosed solder paste printing process, similar to the ProFlow, Crossflow, or Rheometric Pump. We have older MPM AP25's with a custom transport. Speedline told us that in order to add the RheoPump,
Electronics Forum | Fri Apr 21 00:56:44 EDT 2006 | pavel_murtishev
Good morning, MPM AP25 we have is equipped with dedicated vacuum support only, no side snuggers. Also we had a lot of issues with fine pitch paste deposition due to this poor support. Vacuum support can�t fix wrapped boards properly causing a lot of
Electronics Forum | Fri Apr 30 15:11:53 EDT 2004 | pjc
MPM has a new board support system called GelFlex. It can be used on UltraPrint 2000 machines as well as AP series, UP1500 and AccuFlex models. For more info, go to http://www.speedlinetech.com/mpm/gel-flex.aspx also, contact Chris Wild at Speedline
Electronics Forum | Tue Jul 13 13:58:50 EDT 1999 | JohnW
| We are looking to automate the paste printing portion of our SMT process. We are looking at used equipment from DEK and MPM from 1994 onward.(DEK 260 & 265 MPM AP20 & AP27) Does anyone have some feedback or concerns with any of these machines? Does
Electronics Forum | Tue Jul 13 13:30:16 EDT 1999 | Bill Bannister
We are looking to automate the paste printing portion of our SMT process. We are looking at used equipment from DEK and MPM from 1994 onward.(DEK 260 & 265 MPM AP20 & AP27) Does anyone have some feedback or concerns with any of these machines? Does t
Electronics Forum | Wed Feb 09 14:48:30 EST 2005 | tinkergaloot
can anyone provide me with information on the operation of the Zevatech Print-MAT 220? Its a pretty basic machine, but my question relates directly to the squeegee blade setup and leveling the blades to the stencil. If you level the blades together
Electronics Forum | Mon Apr 26 08:15:37 EDT 2004 | pjc
MPM uses a one-print-Mylar system, as do other printer mfrs. In this system there is a Mylar sheet attached to a frame that is secured over the printer table with the board on it. You print onto the Mylar. The table X-Y-theta manual adjustments are u
Electronics Forum | Mon Jul 29 09:19:00 EDT 2002 | pjc
Quick Change Tooling is one advantage for DEK when comparing the MPM UP2000. DEK has Form Flex. Good system, but I've heard concerns about long term dependabilty. All support tooling options offered on the UP2000 takes a bit of time to set up. So, If
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Mon Apr 18 09:52:36 EDT 2005 | pjc
FormFlex and the GridLok system will not work on a semi-automatic printer. They were designed for fully automatic machines. The print table is very shallow on the DEK 248, SMTechs and MPM SPM, UP100 and MicroFlex. DEK should have magnetic base suppor
