Electronics Forum | Tue Jan 08 16:25:00 EST 2013 | eduardo3mx
hello I need your help I have a machine mpm ultraprint3000 with the damaged hard drive I made a copy to the hard drive of another machine the same, but I have problems with the x-axis origin does not, either the track center, and the stencil wiper w
Electronics Forum | Fri Jul 18 16:04:31 EDT 2014 | comatose
We had this. The anti-backlash nuts were binding. We took them apart, chased the threads with a tap and re-assembled with slightly less pre-load. Hasn't been a problem since.
Electronics Forum | Fri Jul 18 10:10:21 EDT 2014 | proceng1
We've got an MPM Accuflex printer that generally works great, but we've had a recurring problem. The powered rail (rear rail) fails to initialize. Sometimes all it takes is restarting the machine to get it to work. At the suggestion of the repair
Electronics Forum | Mon Jul 21 11:01:11 EDT 2014 | dontfeedphils
I dealt with the same issue for a month or so. We jumped through a lot of hoops, replaced both lead screws, verified the motor was good, a ton of stuff. Ended up being an intermittent wire connection between the control board and the conveyor width
Electronics Forum | Mon Jul 21 06:18:15 EDT 2014 | digar
We had this. The anti-backlash nuts were binding. > We took them apart, chased the threads with a tap > and re-assembled with slightly less pre-load. > Hasn't been a problem since. > We had this. The anti-backlash nuts were binding. > We took t
Electronics Forum | Fri Jul 25 10:11:36 EDT 2014 | cgreiner
We also had this problem and found similar results with the anti-backlash nuts binding. We went through the process of cleaning the lead screws and the nuts which resolved the problem for about 6 months only to have it return. We learned that the
Electronics Forum | Fri Jul 25 10:13:01 EDT 2014 | cgreiner
We also had this problem and found similar results with the anti-backlash nuts binding. We went through the process of cleaning the lead screws and the nuts which resolved the problem for about 6 months only to have it return. We learned that the
Electronics Forum | Thu Apr 26 13:16:28 EDT 2018 | bobpan
I am trying to figure out how to teach the position of the tooling so that its aligned to the hole in the worknest. In other words...the carousel is out of position. When i go into machine calibration and i step through it the process freezes at a st
Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit
I had as I placed the supports at the back - when lifting Z touched the rear rail - check.
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
