Electronics Forum | Thu Feb 22 15:25:16 EST 2007 | russ
Hmm our table is steel. We had extra supports made at a machine shop, bought the magnets from the hobby store. we basically just had steel rods cut off at 1" lengths and had a counterbore drilled to glue magnet in Russ
Electronics Forum | Tue Mar 28 19:56:47 EDT 2017 | aemery
Dale, Be very careful about putting to much grease into this actuator. It is kind of a sealed unit. If you were to take this actuator apart you would see that the motor drives a heavy pitched threaded screw. As it turns it causes the threaded tube
Electronics Forum | Wed Aug 02 15:19:29 EDT 2006 | SWAG
Sounds like air pressure is set O.K. The next thing to check is that the platen surface that the x and y axis ride on is perfectly clean. After that, you should knock the camera off the platen and make sure that all of the small air nozzles are blo
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
| 1 |
.gif)
winsouce.jpg)