Electronics Forum | Wed Apr 24 13:49:19 EDT 2019 | griinder
I have a support question concerning setting the gridlock tooling in manual mode on a MPM Momentum Elite. I am printing the top side (bottom is populated with parts) of a thin, flimsy PCB. The Grid lock tooling bows the PCB upwards in Auto mode, beca
Electronics Forum | Tue Jun 01 18:06:36 EDT 2004 | Rob
I used an Ultraprint 2000 so if that's what you use then maybe I might be able to help. First, I'm assuming that you've already passed the Teach New Board section. This is board dimension, X and Y boardstop, stencil/squeegee heights and strokes. If
Electronics Forum | Fri Mar 23 14:13:20 EST 2001 | mnaddra
RW, I have Screened Adhesive on to several different assemblies and have found that when it is possible I get a much better result than with a dot deposition process (The green strength was greatly improved), the biggest issue I ran in to was the pr
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
| 1 |
winsouce.jpg)