Electronics Forum | Mon May 12 11:59:12 EDT 2008 | vms
todd the best answer is this" don't use the dispenser it will waste to much solder paste" Harry
Electronics Forum | Fri May 09 14:56:37 EDT 2008 | markhoch
The paste dispensers work well as long as the humidity in your shop is properly controlled. If it gets too humid, and the paste gets "soupy", then it will take less air pressure to dispense it onto the stencil. Paste dispensers use a controlled, pre-
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Tue Nov 08 16:21:37 EST 2011 | nevercry14
Cannot zero set machine actuator problem need help.
Electronics Forum | Wed Nov 09 08:29:51 EST 2011 | nevercry14
Found y sterper motor not working .nthanks for the info.
Electronics Forum | Tue Nov 08 18:27:50 EST 2011 | dekhead
Not a lot of info; first thought is 12VDC - PSU, breaker, fuse http://www.dekhead.com
Electronics Forum | Fri May 02 10:02:06 EDT 2008 | mmjm_1099
I have used the MPM dispensers and had no past issues with this.
Electronics Forum | Sun May 04 19:50:49 EDT 2008 | vms
todd we can give you info on the dispensers. worked for mpm and know them quite well. call 740-403-9406 if you wish, we don't post on the site. Harry
Electronics Forum | Mon May 12 10:46:13 EDT 2008 | cyber_wolf
Harry...I totally understand what you mean. Was just curious.
Electronics Forum | Fri May 02 09:35:20 EDT 2008 | toddl
Hi everyone, I am looking for positive and negative feedback on the use of the paste dispensing system on MPM screen printers. We currently have four machines with this capability that we do not use. Our printer operators insist that the dispensing s
